Spec Sheet

ManualsBrandsDitek ManualsElectronics66 Block Punch Down Surge Protector

Every precaution has been taken to ensure that this literature is accurate and complete. DITEK Corporation assumes no responsibility and disclaims all liability for damages resulting from the use of this information or for any errors or omissions.

One DITEK Center 1720 Starkey Road - Largo, FL 33771

Phone: 1-800-753-2345 Direct: 727-812-5000

Technical Support: 1-888-472-6100

www.diteksurgeprotection.com

Doc. Number: SPS-100008-001 Rev 9 06/17

Page 1 of 1

Example: DTK-4PLV

DTK-4PLV 4 Pairs

24 Volts

Technical Specifications

Protection Modes:

Tip-G, Ring-G (All)

Surge Current Rating:

2,000 Amps per pair (5V – 48V)

9,000 Amps per pair (75V – 130V)

Max. Continuous Current:

Unlimited (parallel installation)

Mechanical Characteristics

Connection Method:

Punch down on M150 “66” Block

Housing:

ABS

Operating Temperature:

-40°F - 158°F (-40°C - 70°C)

Maximum Humidity:

95% non-condensing

Dimensions (1 – 4 Pairs):

.2.39“L x 2.23“W x .845“H

(60.7mm x 56.6 mm x 21.5mm)

Dimensions (8 Pairs):

7.15”L x 1.7”W x 1.”H

(181.6mm x 43.2mm x 25.4mm)

Weight:

1.6 oz

Quality, Standards & Approval

Agency Approvals:

UL497B

Warranty:

Ten Year Limited Warranty

Selection Guide

VOLTAGE LEVEL

OPX

SPK

SGR

RUV

Pairs Available:

1, 2, 4

Service Voltage:

12V

24V

48V

75V

95V

130V

MCOV:

18VDC

38VDC

66VDC

102VDC

127VDC

175VDC

Clamping Voltage:

22V

47V

82V

119V

150V

204V

Telephone wiring is the single most common application of

surge protection in the low voltage industry. While there are

new technologies being created every day, there are some

technologies that don’t change.

DITEK’s DTK-P Series is designed to protect telco and

building-to-building runs that require unlimited current. Each

pair of protection is represented by a red and a green lead.

Simply terminate a set of leads for each pair of wiring on any

punch block, and provide a ground to dissipate excess

energy.

Product Features

 Protect 1, 2, or 4 pairs to match your system

configuration needs

 Each pair of protection is represented by a red

and green lead

 Flying leads allow connection via down blocks

or wire terminals

 Parallel device – for high current applications

Applications

 Telco Lines

 Low Voltage Loop Circuits

 70V Speaker Circuits

DTK-1PRUV

Summary of content (1 pages)

PAGE 1
Telephone wiring is the single most common application of surge protection in the low voltage industry. While there are new technologies being created every day, there are some technologies that don’t change. DITEK’s DTK-P Series is designed to protect telco and building-to-building runs that require unlimited current. Each pair of protection is represented by a red and a green lead. Simply terminate a set of leads for each pair of wiring on any punch block, and provide a ground to dissipate excess energy.