Data Sheet

DITEK’s D200 industrial surge protectors
are designed to provide protection to AC
power systems in the most demanding
environments. The D200 incorporates
individually fused components for
maximum performance and protection.
Available in a wide range of voltage
configurations, the D200 is an excellent
choice for electrical panel protection.
200kA/ Φ , 100kA/Mode Surge Protective Device
General Product Specifications
D200 Series
D200
One DITEK Center
1720 Starkey Road
Largo, FL 33771
Product Features
• Suitable for use on branch panels and small
disconnects
• Compact size enables close mounting to the
protected panel to minimize wire length and
maximize performance
• 200,000 Amp peak surge current capacity
ensures long service life
• Available in 8 voltage configurations
• Diagnostic LED’s indicates system power,
SPD function, alarm and ground status
• Dry Contacts
• Audible Alarm- With test and disable features.
• Complies with ANSI/IEEE C62.41 and C62.45
Category B and C3 standards
• Ten year limited warranty
Specifications
Agency Approvals: UL 1449, 3
rd
Edition, cUL
IEEE Location Category: Category B and C3
Protector Type: SPD Type 1 (US), Type 2 (Canada)
Peak Surge Current: 200kA/Phase, 100kA/Mode
Short Circuit Current Rating: 100,000A
Protection Modes: See Chart
Temperature Range: -40° – 140°F (-40° – 60°C)
Maximum Humidity: 95% non-condensing
Operating Frequency: 40Hz – 400Hz
Housing: NEMA 4X
Dimensions: 6.3”H x 6.3”W x 2.4”D
(160mm x 160mm x 61mm)
Connection: ¾” NPT conduit, watertight fittings
Weight: 2.9lb. (1.3kg)
Options: Flush Mount Kit, D200-FMK
Dimensions: 9.0” x 9.0” Plate (227mm x 227mm)
Document: SPS-100074-001 Rev 3 11-11
©2011 DITEK Corp.
Specification Subject to Change
1-800-753-2345 Direct 1-727-812-5000
Technical Support: 1-888-472-6100
www.ditekcorp.com
Industrial Surge Protection