Owner's manual

ManualsBrandsDisplay Devices ManualsMicrophonesMFD-100 Microphone Table Lift

tel: 303.412.0399 www.displaydevices.com

fax: 303.412.9346 tech@displaydevices.com

5880 Sheridan Blvd., Arvada, Colorado 80003

MFD-100

Microphone Rotating Lift

Installation Manual

READ ALL INSTRUCTIONS BEFORE BEGINNING INSTALLATION

Thanks for purchasing a Display Devices lift product. We’re sure your customer will enjoy this rotating lift

for years to come. Our products are designed to be maintenance-free saving you future service time. If

you experience any difficulties, please contact us at 303-412-0399. Thank you for your support.

Summary of content (5 pages)

PAGE 1
MFD-100 Microphone Rotating Lift Installation Manual READ ALL INSTRUCTIONS BEFORE BEGINNING INSTALLATION Thanks for purchasing a Display Devices lift product. We’re sure your customer will enjoy this rotating lift for years to come. Our products are designed to be maintenance-free saving you future service time. If you experience any difficulties, please contact us at 303-412-0399. Thank you for your support. tel: 303.412.0399 fax: 303.412.9346 www.displaydevices.com tech@displaydevices.
PAGE 2
IP024-027 RevA MFD-100 Lift Series Installation It is the responsibility of the dealer installer to ensure this product is properly supported and meets all local building codes. DO ensure the table structure is capable of holding at least four times the combined weight of the MFD. This is a minimum requirement. Follow any local or state codes that apply to your specific area.
PAGE 3
IP024-027 RevA MFD-100 Lift Series Installation Figure B 4.) Determine the microphone location and signal pathway and drill a hole in the top plate large enough to accommodate all the required cabling. Removing the connector on the microphone cable will allow for a smaller hole. For a more seamless appearance, have the mill worker attach a matching piece of wood or veneer from the table to the top plate. Another wood surface may be attached in the same manner to the plate in the “down” position as well.
PAGE 4
IP024-027 RevA MFD-100 Lift Series Installation 7.) Before installing the MFD in your table, ensure that the top surface is level. If manual level adjustment is required, unscrew the clamp collar using a 7/64” Allen wrench, adjust the plate until it is level, and retighten the clamp collar. The location of the clamp collar is shown below. Figure D 8.
PAGE 5
IP024-027 RevA MFD-100 Lift Series Installation Using the Remote Control Use the included hand-held remote control unit to initially setup and test the MFD-100. If operating the MFD from a control system, remove the hand-held control and integrate momentary contact closure to pins 1 through 4. There are three buttons on the remote control unit: “HOME,” “SHOW,” and “STOP.” HOME: Unit rotates to the stored position and the microphone/speaker is hidden.