model s800
© 2003 Directed Electronics, Inc
CONGRATULATIONS Congratulations for choosing a Directed Studio neodymium component speaker system from Directed Electronics. Directed Electronics has been the industry leader in high-quality automotive security and audio equipment since 1990, and with the introduction of the Directed Studio line of high-quality loudspeakers for the automobile, Directed continues to set new standards of performance, reliability, and affordability in the mobile electronics industry.
LIMITED TWO-YEAR CONSUMER WARRANTY Directed Electronics, Inc. (DEI) promises to the original purchaser, to replace this product should it prove to be defective in workmanship or material under normal use, for a period of two years from the date of purchase from the dealer as indicated by the date code marking of the product PROVIDED the product was installed by an authorized Directed dealer.
FEATURES Exclusive Directed custom cast aluminum frame. Heavy duty gold-plated three way binding posts. Rugged Santoprene surround. Multi-layered mica filled low resonance 0.7mm polypropylene cone. Tuned to deliver optimum mid-bass response for up front bass. Outboard passive crossovers support three way system design. Custom impedance and frequency matched crossover network. Powerful 140 gram neodymium magnets deliver lower distortion and higher efciency.
SOUND QUALITY Obtaining the highest quality sound reproduction in the mobile environment requires installation techniques and knowledge of vehicle interiors that go far beyond simple replacement of stock speakers. Speaker location, orientation, phasing, and the vehicles interior materials are important considerations when designing and installing an auto sound system.
WOOFER INSTALLATION 1. Mark and cut a 7-5/8” (186mm) hole for mounting the speaker. 2. Drill the holes for the mounting screws using a 1/8” (3mm) drill bit. 3. Route the wiring harness through the mounting hole. 4. Install the spring clips over the holes if needed. Apply the rear mounting gasket to the speaker frame. 5. Attach the wires to the speaker and be sure to observe proper speaker polarity. 6. Place the woofer in the hole. Insert screws through grill clips and woofer mounting holes.
WIRING CONNECTIONS s800 crossover. Connect the negative input on the two-way crossover to the light pass output negative on the s800 crossover. Input 1. Connect the positive from one channel of the amplifier to positive input of s800 crossover. Connect the negative from the same channel of the amplifier to the negative input of the s800 crossover. Output 1. Connect the positive terminal of the s800 midbass to the midbass positive terminal of the s800 crossover.
SPECIFICATIONS Directed model s800 Frequency response Power handling RMS Power handling peak Impedance Magnet weight Vas Fs Qts Efficiency (1W/1M) Mounting Depth Mounting hole diameter Common Driver Specifications: Magnet type Magnet diameter Voice coil forner Voice coil diameter Voice coil layers © 2003 Directed Electronics, Inc 40 Hz - 2 kHz 75 watss 150 watts 3.256 ohms 140.5 g 12.974 L 66.153 Hz 0.25 93.488 2-5/16” 7-1/8” Neodymium 1.
© 2003 Directed Electronics, Inc
© 2003 Directed Electronics, Inc 11
The company behind this system is Directed Electronics, Inc. Since its inception, Directed has had one purpose, to provide customers with the finest vehicle security, car stereo products, rear seat entertainment, and accessories available. The recipient of more than 20 patents in the field of advanced electronic Directed Electronics, Inc. Vista, California 92083 www.directed.com technology, Directed is ISO 9001 registered.