UV Activator Product Manual
Contents 01 Components 02 Specifications 03 Preparations 04 Precautions 05 Product Image 06 Control Panel 07 How to Use 08 Storage After Use 09 Error Messages 10 Troubleshooting – Check Before Calling 11 Service Center
01 Components UV Activator is a device used for the purpose of disinfecting and adding hydrophilic property to medical devices like implant using UV rays. Power adaptor Body Power Product Manual cable 02 Specifications ① Dimensions: 261W X 180D X 348H ② Rated voltage: Input 100-240V Output DC 24V 160W DC Adaptor ③ Power consumption: Max. 150W ④ Frequency: Max. 8MHz ⑤ UV lamp spec: UVC 172nm ⑥ Weight: About 6kg ⑦ Ozone generation: 0.
05 03 Preparations ① Make sure to check that all components are ready. ② Avoid direct sunlight and install in a firm and flat place. ③ Install in a well-ventilated place. ④ Understand the method of use before operating the device. ⑤ Check rated voltage and recheck connection of the power cable. ⑥ Do not use mobile phones or portable telecommunication devices that irradiate electromagnetic waves near this device.
05 Product Image Front Door OPEN: / CLOSE: Operating Part Buttons + Display Card Slot User Card Slot
07 Back Adaptor connector
06 Control Panel Power Button (ON: White / OFF: Red) Display Start Button (Display of user card input, (Started: White / operating status, number of Stopped: Flash) uses and error information) Door Button (Open: White / Closed: Flash) 07 How to Use ① Insert the power adaptor into the inlet socket on the back of the body, and insert the power plug into the 220V outlet. ② Check that the user card has been inserted into the card slot. The device cannot be operated without a user card.
09 ④ Check the number of uses at the bottom right corner. (Left) Remaining count / (Right) Cumulative count ⑤ Press the door button " " to open the top door. RFI D ⑥ Insert the object to be irradiated. ⑦ Press the start button " ". If the object is jammed by incorrectly pressing the door button “ ", press the door button “ " again to open the door and then press the start button “ ". RFI D ⑧ After UV irradiation, the top door opens automatically. Take the object out.
08 Storage After Use ① Ventilate the area after using the product. ② When not in use, make sure to shut power OFF for safety. ③ Store in a place that is free of adverse effects from air pressure, temperature, humidity, ventilation, sunlight, dust, salt and air containing ions. ④ Be careful about safety such as inclination, vibration and shock. ⑤ Do not store in a place with chemicals and gases. ⑥ Keep the power cable and connection terminals clean and neat.
11 11 Service Center Please call the number below if there is a problem in the product.
memo FCC Statement: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference. (2)This device must accept any interference received, including interference that may cause undesired operation. 2.Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
2019.05 UV Activator User Manual ver.