Installation Guide

Table Of Contents

- 6 -

Fig. 1

Fig. 2

Zip-tie to be cut.

Installing the

Transceiver

Transceiver must be

installed before the

heater is secured to a

wall.

1. Using a pair of ‘cutter’

pliers cut the zip-tie to release

the transceiver cable.

2. Re-route the transceiver

cable as shown by the arrow

down towards the rectangular

hole in the base of the

heater. Making sure that the

transceiver cable is on the

outside of all other cables.

PAGE 1
Installing the Transceiver Transceiver must be installed before the heater is secured to a wall. 1. Using a pair of ‘cutter’ pliers cut the zip-tie to release the transceiver cable. Zip-tie to be cut. Fig. 1 2. Re-route the transceiver cable as shown by the arrow down towards the rectangular hole in the base of the heater. Making sure that the transceiver cable is on the outside of all other cables. Fig.
PAGE 2
3. Pull the transceiver cable through the rectangular hole in the base of the heater. Fig. 3 4. Plug the transceiver cable into the socket of the transceiver housing. Fig.
PAGE 3
5. Hook the transceiver housing through the oval shaped slots in the base of the heater. Fig. 5 6. Check that the location hooks of the transceiver housing are located as shown in the picture. Location Hooks Fig.
PAGE 4
7. Using the supplied screws securely screw the transceiver housing into place. Fig. 7 8. On Quantum Size 100 Heater the leg must be attached using the ‘X’ screw holes to allow the transceiver housing to be accessible for maintenance. Fig.
PAGE 5
1 2 ! 3 - $%% ! 4 # 55 & % 6 7 ! ! ( 8 9 1 2 8/9 1 2 2 4 : ;& % # : # % # 4; # # # 2 ( 8 9 ;