User's Manual

Quantum rf System Installation

rf System Required Components:

1. 915MHz Hub.

2. +5V to +12V DC Power Supply.

3. Ethernet Cable.

4. USB to microB Cable (not supplied).

5. Lap Top PC with Quantum LAN Tool installed.

6. Installation/Operation of LAN Tool for Quantum

Hub (three page document).

Rf System Installation:

1. Mount the Hub on a wall near a power outlet, as high as possible.

2. Plug in the power supply and turn on power.

3. Connect to the PC via the USB cable.

4. Start the Quantum LAN Tool.

Refer to the Installation/Operation of LAN Tool for Quantum

Hub document.

5. Power cycle the HUB when the LAN tool prompts you.

The LAN Tool display should now look like this:

6. You are now ready to establish communication to Quantum Storage Heaters with rf

capability. Follow the steps in the Example below.

PAGE 1
Quantum rf System Installation rf System Required Components: 1. 2. 3. 4. 5. 6. 915MHz Hub. +5V to +12V DC Power Supply. Ethernet Cable. USB to microB Cable (not supplied). Lap Top PC with Quantum LAN Tool installed. Installation/Operation of LAN Tool for QuantumTM Hub (three page document). Rf System Installation: 1. 2. 3. 4. Mount the Hub on a wall near a power outlet, as high as possible. Plug in the power supply and turn on power. Connect to the PC via the USB cable. Start the Quantum LAN Tool.
PAGE 2
Quantum rf System Installation Example of System setup: This example will guide you through a typical setup. For this example we will assume there are 4 Quantum storage heaters installed in a home or office and all 4 storage heaters have 915MHz transceivers installed and rf comms enabled. We will also assume that the 4 storage heaters are powered on and the above rf system installation has been completed. 1. Left click the “List Config” button in the top left hand corner of the LAN Tool window.
PAGE 3
Quantum rf System Installation Reading Paired Appliances: 1. You can read data from a paired appliance by left clicking the “Read paired apps” button and selecting Yes or No for a particular appliance, when prompted. Below is an example of the data returned after a read. FCC ID:Z4900005 IC: 6592A-0005 This device complies with Part 15 of the FCC Rules and with Licence exempt RSS standards of Industry Canada.