|Page Table of Contents Types of WeatherNode weather monitoring nodes ..................................................... 3 WeatherNode Operational Modes ............................................................................. 4 1. 2. Gateway .................................................................................................... 4 Standard .................................................................................................... 4 Identifying Types of Antennas .............
|Page Types of WeatherNode weather monitoring nodes PRODUCT CODE DESCRIPTION RHK-WS1 Nodes have two radios and external connectors for antennas. Power sources and sensors are configurable based on type and application. *The node type is on the product sticker located on the bottom of the unit. Example: - Product Code: WS1 Date Created: MM/YY/DD FCC ID: RHK-WS1 Serial:00000x DigitalPath, Inc. 1065 Marauder St., Chico, CA 95973 | 800-676-PATH |www.digitalpath.
|Page WeatherNode Operational Modes 1. Gateway Aggregates data from standard nodes and forwards it to a database over an Internet connection. 2. Standard Collects data from attached sensors and internal components and forwards it to a gateway node. Standard nodes collect and forward data to other standard nodes. DigitalPath, Inc. 1065 Marauder St., Chico, CA 95973 | 800-676-PATH |www.digitalpath.net CONFIDENTIAL © 2005-2019 DigitalPath, Inc.
|Page Identifying Types of Antennas WeatherNode gateway and standard nodes can be equipped with different types of antennas combinations. 900 MHz External Omni 48mm 2.5 dBi Gain 900 MHz External Sector 580x125x50mm 11 dBi Gain **Additionally, the antennas must have an RF exposure separation of 1-meter from a person. This antenna should be mounted only to poles or tower locations where a person will not come within 1-meter of said antenna. 900 MHz External Omni 61in 6 dBi Gain DigitalPath, Inc.
|Page WeatherNode Installation Guide Professional Installation Only WeatherNode weather monitoring nodes require professional installation. This product cannot be purchased by the general public, the intended use is specific to utility companies. Proper installation requires the units to be placed on utility poles or transmission towers in proximity to live, unprotected electrical lines. Only properly trained personnel, using proper equipment should attempt to install or service monitoring nodes.
|Page FCC Compliance & Installation Statement 1. 2. This is a Class B digital device. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.