Installation Guide

INSTALLATION GUIDE
1135 Wireless Siren
Description
The Model 1135 Wireless Siren provides up to 110 decibels of annunciation and
comes with a wall and cover tamper, survey LED, and two batteries. Multiple
sirens can be activated simultaneously by the panel via the Trip with Panel Bell
feature.
What is Included
• One 1135 Wireless Siren
• Two 3.0V Lithium CR123A batteries
• Hardware pack and serial number labels
Programming the Siren in the Panel
Refer to the panel programming guide as needed. In Output Information, enter
an output number, output name, eight-digit serial number, supervision time,
and set the Trip with Panel Bell option to YES. Outputs operate with a 3 second
response time when used with the 1135.
Trip with Panel Bell Option
Select YES to have the siren follow the panel bell output and bell cutoff time. The ON/OFF state of the siren cannot be
changed via the output menu or any other panel function. Default is YES.
Installing the Siren
Tamper Switches
The 1135 is equipped with a case tamper and a wall tamper. See Figure 2. A two position
header is provided to disable the wall tamper. See Figure 3. To disable the wall tamper,
place the jumper across the two pins of the header. Disable the wall tamper if mounting
using the supplied double-sided tape.
100/110 Decibel Jumper
The siren is equipped with a 100/110 decibel (dB) jumper and a two-position header to
change the decibel output. The siren is shipped at the 110 dB output level with the jumper
placed on one pin for storage. If the 100 dB setting is required, place the jumper over both
header pins. See Figure 3.
Selecting a Location
The 1135 siren's LED survey capability allows one person to conrm
communication with the receiver. The PCB Red Survey LED turns on brightly
whenever data is sent to the receiver then immediately turns off when the
receiver acknowledgement is processed. See Figure 3. Press the tamper switch
to send data to the receiver to conrm operation. When the 1135 does not
receive an acknowledgement from the receiver, the survey LED remains on for
8 seconds to signal that communication is not established. Communication is
also faulty when the LED ashes brightly multiple times in quick succession.
Relocate the siren or receiver until the LED immediately turns off when
tampered. Proper communication between the siren and receiver is veried
when for each press or release of the tamper switch, the LED blinks
immediately on and immediately off.
Note: Mount the siren away from metal objects. Do not install the 1135 within 4 feet of the panel
as the RF gain of the transmitter may inhibit proper communication.
Mounting the Siren
1. Remove the locking screws from the top and bottom of the siren housing
and lift the cover from the bottom to remove.
2. Install the included two 3.0V Lithium CR123A batteries. See Figure 3.
3. Mount the 1135 on a at wall. Use the supplied screws in the mounting
hole locations shown in Figure 3, and insure the wall tamper makes
proper contact with the wall. Or, if using the supplied double-sided tape
to attach the siren to the wall, be sure to disable the wall tamper.
4. Set the cover back into place and replace the locking screws.
Figure 1: 1135 Wireless Siren
Figure 2: Wall Tamper
Wall Tamper
Mounting Holes
Mounting Holes
SOUNDER
Red Survey LED
100/110 dB
Header
Wall Tamper
Header
Figure 3: Mounting Holes and
PCB Features