User's Manual

ManualsBrandsDigital Guard Dawg ManualsElectronicsiKEY Premier

iKEY Premier

USER MANUAL

iKEY SYSTEM FUNCTIONS

1. Proximity Door Unlock / Alarm Disarm

Approach the vehicle and when the iKey enters the sensing range, the system will disarm and unlock the

doors immediately. If horn enabled, the parking lights will flash 2X. If siren enabled, the parking lights and

siren will flash and sound 2X.The status LED indicator light will flash BLUE to indicate the system is

disarmed.

2. Proximity Door Lock / Alarm Arm

Walk away from the vehicle and after the iKey exits the sensing range, the system will arm and lock the

doors immediately. If horn enabled, the parking lights will flash 1X. If siren enabled, the parking lights and

siren will flash and sound 1X. Status LED indicator light will flash BLUE and RED alternatively to indicate the

system is armed.

3. Remote Unlock / Disarm

While the iKey is outside the proximity sensing range: Press and hold the UNLOCK button for 1 second to

manually disarm and unlock the doors. If no door is opened and LOCK button is not pressed within 30

seconds, the system will re-arm and re-lock the doors automatically 30 seconds later. If any door is

opened and then closed within 30 seconds, the system will re-arm and re-lock the doors immediately 30

seconds later. If any door is opened but not closed within 30 seconds, the system will re-arm and re-lock

the doors 5 seconds after all the doors are closed.

4. Remote Lock / Arm

While the iKey is outside the proximity sensing range: Press and hold the LOCK button for 1 second to

manually lock the doors and arm the vehicle.

With the iKey is within the proximity sensing range: Press and hold the LOCK button for 3 seconds to

override iKey function and manually lock the doors.

Caution: Doors will not be opened until iKey exits and re-enters the sensing range. **DO NOT LEAVE

IKEYS INSIDE THE VEHICLE WHEN NOT PRESENT.

5. EMERGENCY CARD Unlock and Alarm Disarm

Your Emergency Card provides an alternative method to gain access and start your vehicle. It’s useful in the

event your iKey becomes lost, damaged, battery depleted, submerged in the liquid, etc.

Place your Emergency Card next to the bypass antenna for 5 seconds to disarm, unlock doors and enable

the Push-Start Ignition system. Once the Emergency Card is removed from the bypass antenna, the system

will lock and arm after 30 seconds. User must enter and start the vehicle within this 30-senond window to

avoid triggering alarm function. If longer disarm time is required, leave the Emergency Card over the bypass

antenna to disarm continuously.

Note:

Summary of content (8 pages)

PAGE 1
iKEY Premier USER MANUAL iKEY SYSTEM FUNCTIONS 1. Proximity Door Unlock / Alarm Disarm Approach the vehicle and when the iKey enters the sensing range, the system will disarm and unlock the doors immediately. If horn enabled, the parking lights will flash 2X. If siren enabled, the parking lights and siren will flash and sound 2X.The status LED indicator light will flash BLUE to indicate the system is disarmed. 2.
PAGE 2
1. After driving with the Emergency Card, turn off the ignition, the Start Button will be deactivated after 10 seconds. 2. The Key-Not-Found Reminder Function will be activated while driving with the Emergency Card. 6. Remote Trunk Release To release the trunk, press and hold the TRUNK RELEASE button for 3 seconds. Please note the system will disarm the vehicle before opening the trunk. Make sure to close the trunk and arm the system when done. Note: 1.
PAGE 3
can restart engine by applying brake and pressing the start button. Tachless Mode Non-Diesel Vehicle: ⚫ Apply the brake and press -and-hold the start button to START. The starter cranks so long as the button is being pushed ( up to 6 seconds). This can be done from any mode (OFF, ACC or ⚫ ON). Alternatively in an emergency situation, without applying the brake while in OFF state, press-and-hold the start button for 3 seconds to engage engine to START, release button after engine started.
PAGE 4
12. Remote Start Ignition Take Over Procedure After vehicle is remote started, use the following steps to takeover ignition without restarting the engine: 1. Approach the running vehicle with a valid iKey to disarm alarm and unlock doors. 2. Enter the vehicle and without stepping on the brake, press the Start button once. 3. Step on the brake to exit Remote Start mode. (Start Button’s status LED turns OFF and backlight stays ON) Vehicle is now safe to take out of the Park to drive. 13.
PAGE 5
within 10 seconds, the horn will honk twice to confirm. Repeat the operation to enable this function, the horn will honk once to confirm 16. Door-Not-Closed Reminder Function Leaving the iKey sensing range with the doors open or ajar will trigger the Door Not Closed Reminder. Vehicle will chirp the horn and flash the parking lights twice to warn the driver that one or more doors are not closed. The system will remind the driver 3 times in total.
PAGE 6
21. Vehicle Battery Power Saver Function System will reduce the iKey search frequency after 7 days of inactivity to conserve vehicle battery. In this case, the Smart Key sensitivity will be reduced and it takes longer (8-10 seconds) to identify the iKey or the Bypass Transponder Card. Press the UNLOCK button once will also exit the Power Saver mode. 22.
PAGE 7
3. After programming any quantity of transmitter or bypass card, all data of the transmitter(s) and/or bypass card(s) programmed last time will be deleted. 4. In the same programming mode, if program a transmitter for the second time, the horn will honk 3 times indicating this transmitter has already been programmed. 5. The system can program up to 4 iKey transmitters and 2 Bypass cards. Dip Switch Settings A. B.
PAGE 8
FCC Requirement changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.