K001-00777-00 EVO-HD User’s Guide Copyright © 2019, Digital Ally, Inc. All Rights Reserved, Printed in U.S.A. This publication may not be reproduced, stored in a retrieval system, or transmitted in whole or part in any form or by any means electronic, mechanical, recording, photocopying, or in any other manner without the prior written approval of Digital Ally, Inc.
EVO-HD User’s Guide K001-00777-00 Table of Contents IMPORTANT SAFETY INFORMATION..................... ERROR! BOOKMARK NOT DEFINED. POWERING THE EVO-HD ............................................ ERROR! BOOKMARK NOT DEFINED. BASIC OPERATION ........................................................ ERROR! BOOKMARK NOT DEFINED. INDICATORS AND CONTROLS ..............................................ERROR! BOOKMARK NOT DEFINED. DVF RECORDER .................................................................
EVO-HD User’s Guide K001-00777-00 Section 1: FCC Notice Federal Communications Commission This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.
EVO-HD User’s Guide K001-00777-00 Pre-Event recording will capture up to 30 seconds prior to the start of a recording. Pre-Event Record time is adjustable in 6 second increments Records metadata with the audio and video, including device serial number, vehicle speed, date, time, sensors, radar, and GPS coordinates Automated wireless 802.
EVO-HD User’s Guide K001-00777-00 2.2.
EVO-HD User’s Guide 1 2 3 4 5 6 7 8 9 10 11 13 K001-00777-00 Wireless Microphone input GPS Port: The GPS antenna is connected here. Cell Port: The 4G LTE antenna is connected here. Wi-Fi Port: The Wi-Fi antenna is connected here.
EVO-HD User’s Guide K001-00777-00 Section 4: EVO-HD Power The Power operation is configurable and specifies how the EVO-HD will operate when the vehicle ignition is turned to the ON or OFF positions. Two parameters control the power operation in order as follows: 4.1. Ignition Shutdown Timer The Ignition Shutdown Timer specifies the amount of time the remains EVO-HD fully powered when the vehicle ignition goes from ON to OFF. During the Ignition Shutdown Time: 1.
EVO-HD User’s Guide K001-00777-00 Signal from Trigger Device Configuration Setting Normal or Triggered or Detection Type Threshold Inactive Active State State High to Low Standard 5V GND 12V GND High to Low Standard 28V GND High to Low Standard GND OPEN Low to High Standard GND 5V Low to High Standard GND 12V Low to High Standard GND 28V Low to High Standard OPEN GND High to Low Standard EVO-HD input/output cable interface and wiring color code Wire Color/Code 1. RED WHITE STRIPE 2.
EVO-HD User’s Guide K001-00777-00 Page 9 of 10
Section 6: Contact Information 9705 Loiret Blvd Lenexa, KS 66219 Website: www.digitalallyinc.com Support E-Mail: support@digitalallyinc.com Sales E-Mail: sales@digitalallyinc.com Phone: 913-814-7774 Fax: 913-814-7775 Sales / Support Toll Free: 1-800-440-4947 * Specifications subject to change without notice.