Manual

Table Of Contents

DH200+ Series Touch Screen Monitor Setup (8/16-channel Models only)

DH200+ SERIES TOUCH SCREEN MONITOR SETUP 

(8/16-CHANNEL MODELS ONLY)

The 8-channel and 16-channel DH200+ Series DVRs can be controlled with a touch screen

monitor (not included). Touch screen monitors must be Windows 7® Touch compatible to work

with the system.

NOTE: A firmware upgrade may be required to enable touch screen compatibility. Firmware upgrades

are available as a free download from

www.digimerge.com.

Step 1 of 3: Connect the Cables

The USB cable must be connected to the monitor’s USB port 

and the DVR’s USB port to enable the touch screen function.

USB Port

Power Port

AC power cord

VGA cable

8-channel model shown

USB cable

USB Cable: Enables the DVR to recognize touch gestures on the monitor.

VGA Cable: Transmits video from the DVR to the touch screen monitor.

AC Power Cord: Provides power to the touch screen monitor.

VGA Port

PAGE 1
DH200+ Series Touch Screen Monitor Setup (8/16-channel Models only) DH200+ SERIES TOUCH SCREEN MONITOR SETUP  (8/16-CHANNEL MODELS ONLY) The USB cable must be connected to the monitor’s USB port  and the DVR’s USB port to enable the touch screen function. The 8-channel and 16-channel DH200+ Series DVRs can be controlled with a touch screen monitor (not included). Touch screen monitors must be Windows 7® Touch compatible to work with the system.
PAGE 2
DH200+ Series Touch Screen Monitor Setup (8/16-channel Models only) Step 2 of 3: Power on the Monitor Step 3 of 3: Test the Touch Screen Functions Before you start: 1. Make sure your monitor is turned on. 2. Power on your DVR. 3. Wait for the DVR to boot into the main viewing mode. Access Virtual Remote • While in viewing or playback mode, press and hold anywhere on the screen to access the Virtual Remote. • Tap the Virtual Remote buttons to use the Virtual Remote. • Tap outside the Virtual Remote to exit.