+ DIGIMERGE TOUCH ™ H.264 DIGITAL VIDEO RECORDER WITH TOUCH SENSITIVE CONTROL FREQUENTLY ASKED QUESTIONS English Version 1.0 DH200+ SERIES Right For Business™ www.digimerge.com Copyright © 2011 Digimerge Technology Inc.
FREQUENTLY ASKED QUESTIONS: DH200+ SERIES How do I enable motion-only recording? You must configure the system’s recording parameters in the system’s Main menu. During motion-only recording, the system only records when the system detects motion. When the motion event finishes, the system pauses recording until the system detects motion again. ENABLING MOTION-ONLY RECORDING Step 1 of 3: Enable Motion recording in the Recording schedule 1.
Frequently Asked Questions: DH200+ Series Step 2 of 3 (OPTIONAL): Configure motion detection areas By default, the entire channel area is selected for motion recording. Follow the steps below to customize the area of the channel that you wish to enable motion recording. 1. From the main menu, click CAMERA ( ). 2. From the camera section tab, click on the camera that has motion enabled. Select camera 3.
Frequently Asked Questions: DH200+ Series Step 3 of 3: Configuring Motion Recording frame rates You can configure the recording frame rate when the system detects motion. For example, you may want the system to record in a higher frame rate (30FPS) during motion recording. 1. From the Main Menu, click EVENT ( ). 2. Configure the following beside the channel that has motion enabled: • MOTION: Select the frame rate the system will record at when it detects motion (i.
Frequently Asked Questions: DH200+ Series Enabling Continuous and Motion recording (C+M) In Continuous and Motion recording mode, the system records 24 hours a day. But as soon as a camera detects motion, the system records in Motion recording mode. This allows the system to record at higher frame rates during motion recording, and mark the video as an "event". Step 1 of 2: Enable Continuous and Motion recording 1.
Frequently Asked Questions: DH200+ Series Final Results • The system records continuously with the assigned parameters. In this example, the system will record at 15 FPS during continuous recording. • When the system detects motion, Motion recording begins. In this example, the system will record at 30 FPS when motion is detected (Motion Recording). • When the post-alarm recording ends, Motion recording stops, and continuous recording resumes at 15 FPS.
Frequently Asked Questions: DH200+ Series How do I access the DVR’s Web Server feature? To access the system’s Web Server feature, add : /webserver to the end of your DDNS address. For example, if your DDNS address is http://tomsmith.digimerge.net:80 , you will have to enter the following to access the Web Server feature: http://tomsmith.digimerge.net:80/webserver The Web Server feature allows you to configure your DVR menus and settings remotely. Web Server Installation Steps 1.
Frequently Asked Questions: DH200+ Series 5. Click Next to install the Web Server software. Click Close to complete the installation. How do I remove the Video Loss icon that appears on screen? When the Video Loss icon appears ( ), press the Cancel/ESC button on the remote, or press the UP arrow on the front panel of the system to remove the Video Loss icon.