USER MANUAL WIRELESS RF DEVICE RF_CC2541 Module BL02 TRK-RF-07 REVISION 1.
Table of Content i) Notice ..............................................................................................................................1 ii) Safety Information ...........................................................................................................2 iii) Safety Regulations ..........................................................................................................3 1. General ...........................................................................
i) Notice DIGI® The material contained in this document is proprietary and for information only and is subject to change without notice. Teraoka Weigh-System assumes no responsibility for any errors or damages arising from misinterpretation of any procedure. Screen displays, operating procedures and supporting features might vary with different software version releases. This document shall not be reproduced whether in part or whole without the written consent from Teraoka Weigh-System Pte Ltd.
TRK-RF-07 User Manual ii) Safety Information The operator of the equipment shall comply with the safety and warning indications and procedures outlined in this document. Teraoka Weigh-System Pte Ltd assumes no responsibility or liability for failure to comply with these requirements. For continued protection against fire hazard replace only with battery of same rating and type.
TRK-RF-07 User Manual iii) Safety Regulations Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
TRK-RF-07 User Manual Canada Regulatory Wireless Notice: This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: 1) This device may not cause interference and 2) This device must accept any interference, including interference that may cause undesired operation of the device Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
TRK-RF-07 User Manual End Product Labeling The final end product must be labeled in a visible area with the following: “Contains IC: 5663A-TRKRF07”. Plaque signalétique du produit final Le produit final doit être étiqueté dans un endroit visible avec l'inscription suivante: "Contient des IC: 5663ATRKRF07".
TRK-RF-07 User Manual For Taiwan 警語: 第十二條 經型式認證合格之低功率射頻電機,非經許可,公司、商號或使用者均不得擅自變更頻率、加大功率或變更 原設計之特性及功能。 第十四條 低功率射頻電機之使用不得影響飛航安全及干擾合法通信;經發現有干擾現象時,應立即停用,並改善至無 干擾時方得繼續使用。前項合法通信,指依電信法規定作業之無線電通信。低功率射頻電機須忍受合法通信 或工業、科學及醫療用電波輻射性電機設備之干擾。 IMPORTANT NOTE: 1. 本模組於取得認證後將依規定於模組本體標示審驗合格標籤 2.
TRK-RF-07 User Manual 1. General The module design is based on RF transceiver with integrated MCU core, CC2541. It implements a proprietary communications protocol streamlined to lower cost and power consumption. The antenna used is a PCB antenna. The module will be FCC and TELEC certified for fast and simple integration into end applications. This module may be integrated into a wireless application that operates in 2.4G ISM frequency band. 1.
TRK-RF-07 User Manual 2 Dimension 3.
TRK-RF-07 User Manual 4. Interface Interface pin assignments 1 2 3 4 VDD DD+ GND Notes: 1. The I/O pins is connected to the external interface port directly 2. The voltage level is TTL high/low voltage level.
TRK-RF-07 User Manual 5. Revision Records Serial No. 1 2 3 Date 02/09/2013 16/10/2013 31/10/2013 Edition Status 1.0 1.1 1.