SERVICE MANUAL SD-3100 ESL SD CARD SD-3100 Tentative Edition COPYRIGHT © 2005 TERAOKA WEIGH-SYSTEM PTE LTD
Table of Content i) Notice .................................................................................................................................................1 ii) Safety Information ..............................................................................................................................2 iii) Safety Regulations .............................................................................................................................2 1. General....................
i) Notice DIGI® The material contained in this document is proprietary and for information only and is subject to change without notice. Teraoka Weigh-System assumes no responsibility for any errors or damages arising from misinterpretation of any procedure. Screen displays, operating procedures and supporting features might vary with different software version releases. This document shall not be reproduced whether in part or whole without the written consent from Teraoka Weigh-System Pte Ltd.
ii) Safety Information The operator of the equipment shall comply with the safety and warning indications and procedures outlined in this document. Teraoka Weigh-System Pte Ltd assumes no responsibility or liability for failure to comply with these requirements. • Repair and servicing of product, shall only be carried out by trained and qualified personnel. Disclaimer: Specifications are subject to change without notice. All dimensions shown are approximate.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules.
1. General 1.1 Model Specification Model : SD-3100 Dimension (in mm) : 36.0mm X 24.0mm X 2.1mm Weight : 10g Operating Temperature : 0 °C to +40 °C Humidity : 85% Max.
2.1 Dimension (in mm) 2.1.1 InfoPad (with protective rubber cover) 2.1.
2.2 Overall Layout Rear View Side View 2.
Key Meaning ENT Cursor keys Display Protecting cover • • On/Off key. Use this key to turn the power to the equipment on or off (This key is called the “POWER” key in this document). • • “Enter” key. Use this key to confirm and execute operations. • Use these keys to move the cursor in the desired direction. 240x320 QVGA Colour Transflective TFT & Touch Screen & Backlight To secure the SD-3100 from damage due to drop test Touch panel operation: The equipment has a touch panel display.
2.4 Location of Magnet Area i. ii. InfoPad Magnet Area is for activation of reed switch in RF receiver modules for DIGI proprietary communication purpose. InfoPad Magnet Area & Price Tag Magnet Key Area normally is used for InfoPad printing sticker for selected tag item through the wireless sticker printer.
BS-02 Base Station Service Manual 2.5 InfoPad IP Address And Configuration Setting 2.5.1 InfoPad Wireless IP Address Setting InfoPad is required to set the IP Address for identified in ESL system network communication. Procedure 1) Press Picture button to power on the InfoPad. 2) In the Info Cast main screen, touch [Exit] button. 3) When the password required message appear, enter the correct password and touch [OK]. Note: - Default password is [0].
BS-02 Base Station Service Manual Procedure Picture 6) Select (Start) Setting Network and Dial-up Connection. 7) Select [CF8385PN1] icon and press [ENTER] key button. 8) Set the IP Address and Subnet Mask setting, after finish tap [OK] button to save change setting and exit. Example: IP Address: 192.168.50.150 Subnet Mask: 255.255.255.
BS-02 Base Station Service Manual 3. Revision Records Serial No.