MT-3000 User Manual 1
Copyright Copyright2011 Teraoka Seiko Co., Ltd. All rights reserved. No part of this document may be reproduced, distributed, translated, or stored in any form without the prior written permission of Teraoka Seiko Co., Ltd. Product specifications are subject to change without prior notice. Disclaimer The contents of this document are provided as is. Teraoka Seiko Co.
on, the user is encouraged to try to correct the interference by one of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help.
Safety Information Please read the following information carefully before using the device for the first time, and keep this Quick Start Guide in a safe place for future reference. Always treat the device with care and keep it in a clean and dust-free environment. Do not expose the device to extremely hot, cold or humid environment. Do not use the device in wet or rainy conditions. Do not charge the device in extremely hot or cold conditions.
Device Overview Handy Terminal No.
13 14 15 16 17 18 19 20 Backlight Key Barcode Reader Reset Key Battery Cover Lock Switch Left Trigger Key Hand Strap Hole Cradle connector Adjust LCD backlight brightness Laser emission aperture for barcode scanning Soft reset key Lock and release battery cover Trigger for barcode scanning Attaching hand strap Charging and Data communication port to the cradle Right Trigger Key Trigger for barcode scanning Cradle No.
Installing/ Removing Battery Install the battery 1. Turn over the Handy Terminal. 2. Slide the battery cover lock switches simultaneously in the direction shown until the battery cover is released. 3. Lift up the battery cover. 4. Insert the battery into the battery compartment. Refer to battery label for the correct orientation. 5. Press the battery cover down firmly until the battery cover lock switches are returned to lock position. Remove the battery 1.
Charging the Handy Terminal 1. Connect the AC/DC adaptor to the DC power connector of the cradle. 2. Plug the other end of adaptor into an electrical outlet. The cradle power LED will turn green when power is supplied to the cradle. 3. Place the Handy Terminal to the cradle slot. 4. Handy Terminal LED will turn Red for charging. When charging is complete, the LED will be off.
Status Bar Icon Description ActiveSync connection WLAN connected WLAN searching WLAN off WLAN auto off Bluetooth Off: Grey Bluetooth Scanning: Yellow Bluetooth On: Blue Battery indicator Battery charging Tap to show input keyboard Tap and hold to select input method Tap to switch application Start menu 9
Connecting WLAN 1. Select My Device > Control Panel > WLAN 2. In WLAN Properties, select ON/OFF button to turn WLAN on. 3. Select Choose Network to search for available WLANs within range 4. Select the desired WLAN > Connect & Lock 5.
To unlock the fixed SSID connection, select the connected WLAN and then select Unlock. Connecting Bluetooth 1. Select My Device > Control Panel > Bluetooth 2. In Bluetooth Manager, select ON/OFF button to turn Bluetooth on.
3. Select Search > Search 4. Select the desired device > preferred service type > Add Service 5.
Cascading Multiple Cradles 1. Release the DC power extension cable from locking position at the bottom of cradle. 2. Plug the DC power extension cable to the DC power connector of another MT-3000 cradle. 3. Repeat above steps to connect up to maximum 5 MT-3000 cradles together. To fix the cascading cradles firmly, it is recommended to mount the cradles with the optional mounting plate accessories on a flat and stable surface. Copyright 2011 Teraoka Seiko Co., Ltd All rights reserved. http://www.