SERVICE MANUAL IFT-21542 INFOTAG 1.
Table of Content i) Notice ................................................................................................................................................. 1 ii) Safety Information .............................................................................................................................. 2 iii) Safety Regulations ............................................................................................................................. 2 1. General ................
i) Notice DIGI® The material contained in this document is proprietary and for information only and is subject to change without notice. Teraoka Weigh-System assumes no responsibility for any errors or damages arising from misinterpretation of any procedure. Screen displays, operating procedures and supporting features might vary with different software version releases. This document shall not be reproduced whether in part or whole without the written consent from Teraoka Weigh-System Pte Ltd.
ii) Safety Information The operator of the equipment shall comply with the safety and warning indications and procedures outlined in this document. Teraoka Weigh-System Pte Ltd assumes no responsibility or liability for failure to comply with these requirements. • Repair and servicing of product, shall only be carried out by trained and qualified personnel. Disclaimer: Specifications are subject to change without notice. All dimensions shown are approximate.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules.
NCC 警語： 第十二條→經型式認證合格之低功率射頻電機，非經許可，公司，商號或使用者 均不得擅自變更頻率、加大功率或變更原設計之特性及功能。 第十四條→低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有 干擾現象時，應立即停用，並改善至無干擾時方得繼續使用。 前項合法通信，指依電信法規定作業之無線電通信。 低功率射頻電機須忍受合法 通信或工業、科學及醫療用電波輻射性電機設備之干擾。 4
IFT-21542 Service Manual 1. General 1.1 Model Specification Model : IFT-21542 Dimensions (in mm) : Infotag 1.54 (BW/R) LCD Size Display Window LCD Resolution Weight : 20g approx. Power Source : DC Cell Button Battery 3.0V x 1 Operating Temperature : 0 °C to + 40 °C Humidity : 85% Max. Non-condensing IP Rating : TBA Housing material : PC plastic casing, PC battery cover Battery Specification : Type Nominal Voltage Life Time Weight 5 - - 46.2 (L) X 38.7 (H) X 11.9 (W) 31.
IFT-21542 Service Manual 2.
IFT-21542 Service Manual 3. IFT-21542 Setup Diagram & Spec Setting 3.
IFT-21542 Service Manual 3.2 Exploded View IFT-21542 Front Cover LCD & PCBA Back Cover Battery Battery cover Note: This product is fully sealed by Ultrasonic Welding process. (Above the information is only reference for factory and Technical department.
IFT-21542 Service Manual 3.3 Replacement of Info Tag Battery Location of Battery in Info Tag Battery Cover Battery Info Tag i. ii. Pull off the battery cover from back of the Info Tag. Replace the new battery. (Ensure the Battery polarity is correct) Caution: Dispose of the Battery according the Safety Guideline. + i. ii. iii. iv. v. Avoid placing the battery in reverse polarity. Do not heat or dispose of fire. May burst or release toxic material. Do not charge. Do not short circuit.
IFT-21542 Service Manual 3.6 Product Handling of Info Tag Handle product with care. Do not expose product to corrosive chemical solution, any organic solvent acidic or alkaline. If cleaning is required, wash only water or mild soap solution. Do not attempt to disassemble, apply force or heavy load to the product. No user serviceable parts inside.
IFT-21542 Service Manual 4. Revision Records Serial No. Date Edition Status 001 AUG 15 00 Description of Changes First Release 11 Software Version Remarks V0.
