SERVICE MANUAL IB-3500 RF BASE STATION IB-3500 Tentative Edition COPYRIGHT © 2005 TERAOKA WEIGH-SYSTEM PTE LTD
Table of Content i) Notice .....................................................................................................................1 ii) Safety Information ..................................................................................................2 iii) Safety Regulations .................................................................................................2 1. General .......................................................................................................
i) Notice DIGI® The material contained in this document is proprietary and for information only and is subject to change without notice. Teraoka Weigh-System assumes no responsibility for any errors or damages arising from misinterpretation of any procedure. Screen displays, operating procedures and supporting features might vary with different software version releases. This document shall not be reproduced whether in part or whole without the written consent from Teraoka Weigh-System Pte Ltd.
ii) Safety Information The operator of the equipment shall comply with the safety and warning indications and procedures outlined in this document. Teraoka Weigh-System Pte Ltd assumes no responsibility or liability for failure to comply with these requirements. • Repair and servicing of product, shall only be carried out by trained and qualified personnel. Disclaimer: Specifications are subject to change without notice. All dimensions shown are approximate.
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: - Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
IB-3500 Base Station Service Manual 1. General 1.1 Model Specification Model Dimensions (in mm) : : IB-3500 Body Casing Dimension With Upright Antenna - 230(L) x 210(W) x 51(H) - 230(L) x 210(W) x 205.5(H) Color : White LED (x4) : Red Green Orange Red Reset Button : 1 x Mechanical Switch Antenna (x4) : Antenna Color (White) 2 x Transmit Data (TX) 2 x Receive Data (RX) Weight : 1500g approx.
IB-3500 Base Station Service Manual 1.2 DC Specification Power Source : External : Ethernet Cable from POE Switch Port (48 Volt DC) : Internal NA Operating Temperature : 10ºC to +40ºC Humidity : 85% Max. Non-condensing 1.3 : RF Specification RF Standard : FCC ARIB STD-T66 NCC, C-TICK, IC, CE Modulation : GFSK, MSK Frequency Band : 2.402GHz to 2.475GHz Channel list : 73 Channels Transmit Power : 16.35dBm (GFSK) 8.
IB-3500 Base Station Service Manual 2. Dimension “R”ound projection denotes “Receiver” Antenna 210 230 51 205.
IB-3300 Base Station Service Manual 3. IB-300 Station Setup Diagram & Spec Setting 3.1 Setup Diagram Front View Top View ANTENNA TX LED RX LED Power LED Reset Button Reset LED Ethernet (POE Port) LED / BUTTON Power LED (Red) • Power On Indicator. Descriptions TX LED (Green) • The indicator light will be stay ‘On’ or ‘Blinking’, when Transmit Data communication is connected. RX LED (Orange) • The indicator light will be stay ‘Toggle’, when Receive Data communication is connected.
IB-3300 Base Station Service Manual 3.2 RF Station Setup Ethernet Straight Cable Ethernet Straight Cable POE Switch PC RF Station PROCEDURE PICTURE 1) Double click open the [Internet Explorer] icon. 2) In the Web Browser, key in the RF Station IP address [192.168.50.49] accesses to RF Station Setting main screen. Note: 192.168.50.49 is Default IP Address 3) In the RF Station Setting main screen, keying the new “IP Address” and “Network Mask”. After that click [Submit] to save change the setting.
IB-3300 Base Station Service Manual 5) Repeat the Step 2, and keying the new IP Address to checking the setting is changed. Note: Ensure the PC IP Address is also change to under same network. (Example: 192.168.50.
IB-3100 Base Station Service Manual 4. Revision Records Serial No.