User Manual

ManualsBrandsDigi-Code ManualsElectronicsGarage Door Opener/Security Device

Table Of Contents

Installation Instructions
- Garage Door Opener Radio Controls
  - Model 5030 (300 mHz) \ 5032 (310 mHz) Three Button Transmitters

Installation Instructions

Garage Door Opener Radio Controls

Model 5030 (300 mHz) \ 5032 (310 mHz) Three Button Transmitters

WARNING:

•

••

•

Disconnect operator power before any installation or repair

•

••

•

Always wear safety glasses

Your Digi-Code radio controls are designed specifically to remotely control a garage

door opener from within an automobile and to give years of trouble free service without

adjustment.

Because all radio controls are set with the even numbered switches in the

“ON” position when they leave the factory, it is recommended that a different code

be selected and set at the time of installation.

Please refer to the “Setting the Code

Switch” section for instructions. The radio frequency (RF) portion of the controls,

however, are tuned to standard frequencies and are thoroughly tested at the factory. This

permits the addition or replacement of either the transmitter or the receiver by specifying

the Model number and the RF frequency designated on the identification label. RF

adjustments are not needed nor should any be attempted.

SECTION #1

SETTING THE CODE SWITCHES

On the transmitter the entire front lower half of the case ( “ the battery hatch” ) is

removeable. Use a coin or the curved end of the visor clip to disengage the lower half of

the transmitter front. This will expose both the code switch and the battery compartment.

( SEE FIGURE #1 )

Summary of content (4 pages)

PAGE 1
Installation Instructions Garage Door Opener Radio Controls Model 5030 (300 mHz) \ 5032 (310 mHz) Three Button Transmitters WARNING: • Disconnect operator power before any installation or repair • Always wear safety glasses Your Digi-Code radio controls are designed specifically to remotely control a garage door opener from within an automobile and to give years of trouble free service without adjustment.
PAGE 2
Figure #1 Once you have removed the battery hatch, locate the “CODE SWITCHES” above the battery. As shown above, the dual buttons are controlled by the right hand switch and the single button is controlled by the left hand switch. Before setting the receiver code switches, you will need to set the transmitter code switches on your model 5030 or 5032.
PAGE 3
SETTING THE SINGLE BUTTON CODE SWITCH Set code switch positions 1 through 10 to your personal code scheme, any combination of “on” or “off” positions can be selected (Note: The switch is in the “on” position when it is depressed toward the number.). We strongly urge that several coding schemes be avoided: ALL ON; 2,4,6,8,10, ON. These positions are similar to our or other manufacturers test positions, or are frequently used.
PAGE 4
TO REPLACE OR ADD A SET A replacement or new transmitter or receiver may be purchased by specifying the Model Number and the RF frequency designated on the serial tag label. The RF frequency is set at the factory and must not be adjusted in the field. The digital code can be matched to the companion receiver or transmitter by following the “setting” procedures above. OPERATIONAL CHECK To check operation, move back about 50 feet and press the transmitter button.