User Manual

ManualsBrandsDigi-Code ManualsElectronicsSecurity Transmitter

Installation Instructions

Garage Door Opener Radio Controls

Model 5040 (300 mHz) \ 5042 (310 mHz) Single Button Mini Transmitters

Model 5050 (300 mHz) \ 5052 (310 mHz) Dual Button Mini Transmitters

WARNING:

•• Disconnect operator power before any installation or repair

•• Always wear safety glasses

Your Digi-Code radio controls are designed specifically to remotely control a garage

door opener and to give years of trouble free service without adjustment. Because all

radio controls are set with the even numbered switches in the “ON” position when

they leave the factory, it is recommended that a different code be selected and set at

the time of installation. Please refer to the “Setting the Code Switch” section for

instructions. The radio frequency (RF) portion of the controls, however, are tuned to

standard frequencies and are thoroughly tested at the factory. This permits the addition or

replacement of either the transmitter or the receiver by specifying the Model number and

the RF frequency designated on the identification label. RF adjustments are not needed

nor should any be attempted.

SECTION #1

ACCESSING THE CODE SWITCH AND BATTERY COMPARTMENT

The models 5040, 5042, 5050 & 5052 mini transmitter cases are made up of two halves

which are held together by a small phillips head screw. Removing this screw will allow

access to the code switches and the battery compartment ( see diagram #1 ).

( Diagram #1 )

Summary of content (5 pages)

PAGE 1
Installation Instructions Garage Door Opener Radio Controls Model 5040 (300 mHz) \ 5042 (310 mHz) Single Button Mini Transmitters Model 5050 (300 mHz) \ 5052 (310 mHz) Dual Button Mini Transmitters WARNING: • Disconnect operator power before any installation or repair • Always wear safety glasses Your Digi-Code radio controls are designed specifically to remotely control a garage door opener and to give years of trouble free service without adjustment.
PAGE 2
SECTION #2 SETTING THE CODE SWITCHES ON THE MODEL’S 5040 AND MODEL 5042 SINGLE BUTTON MINI TRANSMITTERS Use your finger to slide the “code switch hatch” from the Digi-Code receiver or locate the code switches on the back of your Stanley operator. The digital code is determined by the position of the 10 small switches numbered 1 through 10 located in the receiver and the transmitter ( see diagram #2 ).
PAGE 3
SECTION #3 SETTING THE ( “RECEIVER” ) CODE SWITCHES - TO WORK WITH MODEL 5050 AND MODEL 5052 DUAL BUTTON MINI TRANSMITTERS Use your finger to slide the “code switch hatch” from the Digi-Code receiver or locate the code switches on the back of your Stanley operator . On the transmitter, locate the phillips head screw on the bottom of the case, removing this screw will allow access to the code switches and the battery compartment ( see diagram # 4 & # 5 ).
PAGE 4
SETTING THE TRANSMITTER CODE SWITCH – MODEL’S 5050 & 5052 On the transmitter, locate the phillips head screw on the bottom of the case, removing this screw will allow access to the code switches and the battery compartment . Once you have done this, locate the code switch and set code switch positions 1 through 9 to your personal code scheme ( THE 10TH POSITION SWITCH MUST BE SET IN THE CLOSED POSITION “ON”), (Note: The switch is in the “on” position when it is depressed toward the number.).
PAGE 5
OPERATIONAL CHECK To check operation, move back about 50 feet and press the transmitter button. Operation should be reliable at this distance but environment and location of both the transmitter and receiver will effect the range. Try different mounting locations and positions in the vehicle. If operation is still undesirable, the problem may be isolated by: 1. Checking the door operator. If the door will not open when the wall button is pressed, the problem is likely to be the operator.