BlueHeat® T91 Remote Owner’s Manual
Operating and servicing manual BlueHeat® T91 General Information Dear Webasto Customer ! We are delighted that you have selected this Webasto product. We assume that the workshop / service center that carried out the installion explained to you the operation and principle of functioning of your Telestart T91 to your complete satisfaction. With these operating instructions we would like to provide you with an overview of the use of the hand-held transmitter Telestart T91.
The heater must not be operated: • In filling stations and tank farms. • In places where explosive vapours or dust may build up (e.g. near fuel, coal, wood dust or cereal stores). • Close to inflammable materials such as: Dry grass and leaves, cardboard packaging, paper, etc. • In enclosed rooms (e.g. garages), not even via the timer or Telestart. Care and handling Note the following points to avoid damage to the Telestart T91: • Do not expose to heat above 70 °C (e.g. direct sunlight).
Programming Telestart Transmitter 1. Place batteries into the battery compartment of the transmitter. 2. Remove fuse 1A (black) from the heater’s fuse holder (voltage interruption). 3. Wait at least 5 seconds. 4. Replace fuse in heater’s fuse holder and within 5 seconds press the OFF button on the transmitter for at least 1 second. 5. “Learning” is completed. A second or third hand-held transmitter can be programmed in the same manner. NOTE: The learning process can be repeated as often as necessary.
Checking the Mode Simultaneously depress and hold down the ON and OFF buttons. LED illuminates: red = heating mode green = ventilating mode LED extinguishes: – when the buttons are released, or – after 10 seconds Mode setting Depress the ON and OFF buttons simultaneously twice within one second. Upon the second actuation, the LED will change its colour and illuminate until the buttons are released. The new mode is stored when the button is released.
NOTE: In the ‘heating’ mode, the vehicle’s heating system is to be set to “warm” prior to leaving the vehicle. In the ‘heating’ and ‘ventilation’ modes, the vehicle’s fan switch is to be turned to position 1 in the case of 3-speed blower fans, and to position 2 in the case of 4-speed blowers. In the case of infinitely variable fans adjust to at least 1/3 of the fan’s capacity.
Checking and Setting the Operating Time The operating time of the heater or the vehicle’s fan can be preset on the transmitter in increments of 10 minutes. The operating time is factory-set at 30 minutes. NOTE: We recommend setting the heating time according to the drive time. Example: The vehicle is used for travelling to work and back. With a driving time of approx. 30 minutes (one way), we recommend setting an operating time of 30 minutes.
Setting the Operating Time Press the OFF button to call up the next operating time. To store the setting: – do not actuate any button for 10 seconds, or – actuate the ON button. Returning to the Default Setting Press the ON and OFF buttons simultaneously for approx. 10 seconds until the LED extinguishes. Default setting: heating mode, 30 minutes. Checking the Batteries Press the ON or OFF button.
FCC Notes (USA) Device FP / PP [statement according to 15.19(a)(3)] “This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.” User Manual FP / PP [statement according to 15.21] “Modifications not expressly approved by this company could void the user’s authority to operate the equipment.
RFExposure portable: This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.” RFExposure mobil: The internal / external antennas used for this mobile transmitter must provide a separation distance of at least 20 cm from all persons and must not be colocated or operating in conjunction with any other antenna or transmitter.” NOTES: 1.) The T91 NA contains toxic substances and has to be decontaminated (dumped) in a corresponding way.
BlueHeat® T91 Remote Owner’s Manual Part Number xxxxxxx ©2007 Webasto Product North America, Inc.