Bluetooth LED stand DL-60BSH Instruction Manual
CAUTION ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ Do not repair, disassemble, or modify under any circumstances. Do not place near any heat sources or in direct sunlight. Place on flat, secure surface. Use ONLY the supplied AC power adaptor. Do not use appliances with frayed or damaged electrical cords. Do not touch electrical appliances with wet hands or when liquids are present. Please keep the light and all appliances dry and clean. Unplug adapter when the light will not be used for an extended time.
LED STAND ■ Main Features LED light Touch type control button Headphone Jack USB Jack DC Jack ■ The Name of Each Part Search FM frequency Telephone mode Volume control BlueTooth FM Radio Brightness Control FM PRESET Power Reading Mode Study Mode Relax.
MULTI-PIVOT-FLEXIBLE POSITIONING PRODUCT BOX CONTAINS A. LED light B. Volume Control button C. Stand prop D. AC adapter E.
Setting and operation ■ LED Stand Touch power button after check Red LED light ON status. (Red LED will be turn off if light is ON status.
■ USB Power Port Allows operation and recharge of any appropriate USB powered device when connected. (Supported 5Volt/700mA connection) ■ Listening to FM Radio ▶ Turn on the Radio by press button FM radio. ▶ Choose your Frequency by SCAN button (Left and Right). ▶ The frequency range is from 87.5 to 108Mhz and search it by 100Khz step. ▶ Press PRESET button and then LED will be turned ON. Press Left-Right key of SCAN button, then you can find and listen to the Radio by your fixed-set frequency.
▶ Call / Receive Call / Hang-Up / Reject Call / Call Transfer Call : Call by mobile phone, RED Led of Call button will be turned ON if lamp got pairing with mobile phone. Receive call : If lamp got pairing with mobile phone, ring at a time by mobile phone and lamp. Red LED of call button will be turned ON and take a phone call by press call button shortly as 0.5 sec. Hang-up : After finish phone call, press call button shortly as 0.5 second. Rejects call : For reject call, press call button during 1.
EU This product is CE marked according to the provision of the R&TTE Directive (99/5/EC). Here by Diasonic Technology co., ltd. declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. FCC STATEMENT This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2.