DA8050W-F (White), DA8050G-F (Gray), DA8050BK-F (Black) Bathroom Vanity 48 inch Weight Limit: 25 Lb / 11.34 Kg Thank you for purchasing from Dorel! Questions, concerns, missing parts? CONTACT OUR CUSTOMER SERVICE DEPARTMENT BEFORE RETURNING PRODUCT TO THE RETAILER. If parts are missing or damaged, we will gladly ship your replacement parts free of charge. Visit www.dhpfurniture.com/eng/replacement-parts or call Toll-Free 1-800-267-1739. You can also chat with us at www.dhpfurniture.
Limited 1 year Warranty Read Before Beginning Assembly Dorel warrants this product to be free from defects in material and workmanship and agrees to remedy any such defect. This warranty covers one year from the date of original purchase from authorized retailers. This is solely limited to the repair or replacement of defective parts and assembly labor is not included.
TOP VIEW BACK VIEW Cut-out for plumbing PARTS B A DIMENSIONS: MILIMETERS [INCHES] 3
PARTS LIST A B VANITY 1PC BACKSPLASH 1PC PART NUMBERS PART LABELS DA8050W-F (White) DA8050G-F (Gray) DA8050BK-F (Black) A T712090 T712110 T712120 B T712100 T712100 T712100 Each part has a unique part number. Please reference the appropriate part number when contacting customer service for replacement parts.
Locate wall studs and use this rail to secure vanity to the wall Step 1 Place the vanity in the desired location. Ensure the vanity is level. Shim legs, if necessary. Locate the wooden studs in the wall and secure the vanity to the wall using wood screws (not provided). Install the faucet and all plumbing. Make sure there are no water leaks.
Step 2 Make sure to apply the silicone to the rough edge of B and that the smooth side is facing forward. B Apply a line of silicone to the bottom edge of the backsplash B and secure it to the vanity A. Wipe away any excess silicone immediately. NOTE: Allow 24 hours for the silicone to fully dry before exposing it to water or to cleaning products.
Step 3 The door alignment was set at the factory, but it might have shifted during transport. Floors can also be uneven, causing doors to be misaligned. If needed, adjust the hinges as shown.
Step 4 The drawer(s) can be removed if needed. Spring clip Locate the spring clip on both sides on the drawer glide. At the same time, press the clips and pull the drawer out. To reinsert, simply align the 2 sides of the drawer glides and slide in until the drawer is fully inserted.
CAUTION: This unit is intended for use only with the products and/or maximum weights indicated. Use with other products and/or products heavier than the maximum weights indicated may result in instability or cause possible injury. Helpful Hints • Ensure all building & plumbing codes are respected. We strongly advise the use of a licensed plumber to install the faucet and plumbing. • Make sure that the vanity is installed on a level floor.
Preguntas, inquietudes, partes que faltan? CONTACTE NUESTRO DEPARTAMENTO DE SERVICIO AL CLIENTE ANTES DE DEVOLVER EL PRODUCTO A LA TIENDA. Si le faltan piezas o las que se incluyen están dañadas, con mucho gusto le enviaremos sus piezas de reemplazo sin cargo extra. Visite www.dhpfurniture.com/spa/replacement-parts , llame gratis al 1-800-267-1739 o chatea con nosotros al www.dhpfurniture.
Partes Piezas de reemplazo, visite www.dhpfurniture.com/spa/replacement-parts Todo se incluye en 1 caja(s) grande(s)! Antes de deshacerse de las cajas de cartón, asegúrese de que estén vacías. También confirme que ha recibido todos los componentes necesarios para el ensamblaje al compararlos con la tabla de piezas indicadas en la sección en inglés.
Instrucciones Paso 1 Coloque el tocador en la ubicación deseada. Asegúrese que el tocador esté nivelado. Ajuste con cuñas, si es necesario. Ubique montantes de madera de la pared y fije el tocador a la pared con tornillos para madera (no incluidos). Instale el grifo y todas las tuberías. Asegúrese de que no haya fugas de agua. Ilustración 2.1: Ubique los montantes de la pared y use este riel para asegurar el tocador a la pared.
Des questions, des préoccupations ou des pièces manquantes? CONTACTEZ NOTRE SERVICE À LA CLIENTÈLE AVANT DE RETOURNER LE PRODUIT AU DÉTAILLANT. Si des pièces sont manquantes ou endommagées, nous expédierons volontiers vos pièces de rechange gratuitement. Visitez www.dhpfurniture.com/eng/replacement-parts , appelez sans frais au 1-800-267-1739 ou clavardez avec nous au www.dhpfurniture.com.
Pièces Pour des pièces de rechange, visitez www.dhpfurniture.com/fre/replacement-parts IMPORTANT: La liste des références ci-dessous est propre à votre produit. Veuillez l'avoir sous la main lorsque vous appelez pour des pièces de rechange. Tout dans 1 grande(s) boîte(s)! Avant de jeter les boîtes en carton, assurez-vous qu'elles soient vides.
Instructions Limite de Poids: 25 lb / 11.34 Kg Étape 1 Placez la vanité à l'emplacement souhaité. Assurez-vous que le meuble repose horizontalement. Placez des cales sous les pieds, si nécessaire. Conseils utiles Trouvez les montants en bois derrière le mur et fixez le meuble au mur à l'aide de vis à bois (non fournies). Installez le robinet et toute la plomberie. Assurez-vous qu'il n’y ait pas de fuite d'eau. Illustration 2.