Instructions / Assembly

ManualsBrandsDEXTRUS ManualsAccessories3.2 Gal. Gray Portable Toilet No Leakage Outdoor Camping Flush Toilet with Waste Tank

ASSEMBLY INSTRUCTIONS

Product speciﬁcation:

1. 10 litre capacity/waste holding tank.

2. Fresh water capacity provides up to 50 ﬂushes.

3. Always ﬂushes with clean water, no water is recirculated completely

self-contained, no external water or power connections required.

4. Attractive matte ﬁnish conceals scratches, clean by scrubbing without damage.

5. Heavy duty, corrosion resistant side latches lock tanks together.

BFTLPT-0000

Portable Toilet

SKU

Summary of content (6 pages)

PAGE 1
ASSEMBLY INSTRUCTIONS Portable Toilet Product speciﬁcation: SKU BFTLPT-0000 1. 10 litre capacity/waste holding tank. 2. Fresh water capacity provides up to 50 ﬂushes. 3. Always ﬂushes with clean water, no water is recirculated completely self-contained, no external water or power connections required. 4. Attractive matte ﬁnish conceals scratches, clean by scrubbing without damage. 5. Heavy duty, corrosion resistant side latches lock tanks together.
PAGE 2
ASSEMBLY INSTRUCTIONS ! Tip: 1. Please always assemble according to the instruction. 2. Ensure water supply pressure is no more than 0.4Mpa. 3. Hot water more than 40 degrees is forbidden. Product List BFTLPT-0000 Toilet x1 Sealed ring of waste cover x1 Handle pump buckle x1 OPP package of each product contains: Toilet lid buckle x2 Manual x1 NO.
PAGE 3
! ASSEMBLY INSTRUCTIONS Caution: ① Place on smooth ground ② Ensure all latches are locked ③ Ensure the waste holding tank is assembled correctly and the cap is screwed on correctly. ④ Bearing weight limit is no more than 200 kg ⑤ Do not lean on seat cover when using Use Operation: 1. Open the fresh water holding tank, ﬁll the tank with fresh water just below the neck mouth and then tighten the cap up. 2. Pull out slide valve before use. 3.
PAGE 4
ASSEMBLY INSTRUCTIONS 5
PAGE 5
Clean Operation: ASSEMBLY INSTRUCTIONS 1. Empty Waste Holding Tank. 2. The waste holding tank has a 10 litre capacity, it should be emptied when contents reach approximately 2cm below the stide valve. 3. Make sure that the slide is pushed in completely before separating the waste holding tank and then release the latches on both sides,hold fresh water holding tank with both hands and move it from above of the waste holding tank. Do not disassemble the slide valve. 4.
PAGE 6
ASSEMBLY INSTRUCTIONS Assembling of Portable Toilet 1. Place waste holding tank in horizontal position and make sure that the sealed circle is in its proper position, hold fresh water holding tank with both hands,unfold latches outward and place the fresh water limber hole to the centre of waste holding tank's slide valve, making sure of a good seal. 2. First lock the latches on the groove of waste holding tank and then hitch the holding tank body, push inward to lock position. 3.