RF WIRELESS MULTIMEDIA MOUSE USER’S MANUAL Model #: MW1053 1
Important Ergonomic Information Some experts believe that using any mouse or trackball may cause serious injury to hands, wrists, arms, neck, or back. If you feel pain, numbness, or weakness in these areas, see a qualified health professional. TO REDUCE THE RISK OF INJURY, FOLLOW THESE PRECAUTIONS: z z z z z Take frequent breaks, Get up and walk around several times every hour. Vary your tasks throughout the day. Keep your shoulders relaxed with your elbows at your side.
Precaution ! Notebook computer is not recommended. This RF wireless mouse is designed to use with desktop computer. PS2 ports of different notebooks have different data format. Some of them might not fully compatible with this RF wireless mouse. Hence, we highly recommend using this RF wireless mouse with desktop computer.
ID channels for both receiver and mouse. Please follow the steps as below to set up: 1. Turn to the bottom of the receiver and you will see a small rectangular hole (take the cover as Fig-2.1) and a slide switch (channel selection, refer to Fig-2.2). 2. Remove the batteries cover by pressing the opening tabs and pull the battery cover(the top cover of the mouse) out (refer the right Fig-2.3). The carrier Fig-2.1 Fig- Fig-2.3 Fig-2.3 channel is set by a slide switch with A or B positions.
Step 4. Establish communication between the receiver and the mouse (select identification codes). Press and release the connect button on bottom of the wireless mouse (refer to Fig-3.1). Use a pen or pencil to press and release the connect button on the receiver (refer to Fig-3.2). The "connect" light on the top dome of receiver will flash while the same ID is selected on both of the receiver and the mouse. Fig-3.1 Battery Warning! When replace the batteries, use alkaline.
Operation Using the Multimedia Functions When you install the included software driver, the left, middle, and side (second, third, and fourth) buttons are all definable to perform 34 functions like : AutoScroll, Backspace, Zoom, Page up, Page down…. F1 …F12 Power saving mode and wake up While this mouse has not been operated for 2 minutes, it will turn into power saving mode. Please move this mouse more than 0.3 second or double click any key switch to wake up the mouse (to stop the power saving mode).
z z z z z z z Dimensions: 120*65*35 mm Weight: 900 grams Receiver Interface: PS2 or USB or USB + PS/2 Power: 5V DC, 100mA MAX connected to host computer Dimensions: 85*85*33 mm Weight: 140 grams ELECTRIC SPECIFICATIONS z Operating Voltage: Transmitter: 1.8 to 3.2V DC (powered by batteries) Receiver: 4.5 to 5.5V DC (powered by PS/2 port) z Operating Current: Transmitter: 11mA Receiver: 30mA typical z Standby Current: Transmitter: 0.
(such as cordless telephone cradle) as far apart as possible. You may need to experiment to determine the locations that are best for your environment. 3. Interference with other RF wireless mouse Please switch the channel to a different carrier. To do so, you need to adjust both receiver and mouse to the new channel (A or B). To reset the channel, please see “Step 2, Setting up the correct channel for both of receiver and mouse” of the installation guide.