Dexatek ∑Casa/SmartCasa Quick Installation Guide ∑CASA
1. ∑Central/Smart Gateway 3 1.1. First time to use ∑Central/Smart Gateway 3 2. The steps before you add any peripheral 5 3.
1. ∑Central/Smart Gateway 1.1.
5 6 Follow the instruction on App to set up your ∑Central 根據APP上的指示進行安裝 請按住ΣCentral中間鈕3秒直 到顯⽰示燈快速閃爍。 ! 7 Push the RESET button and hold for 3 seconds until the Orange LED flash quickly 8 Select the WiFi router to be connected 選擇欲連接的WiFi router 4 Switch to [Device] tab, You will see the information of location and weather forecast.
2.
3. ∑MotionSense/Smart Motion Sensor 1 3 2 Open the battery cover and put one ER14250 1/2AA battery 打開電池蓋並裝⼊入電池 Pairing with ∑Central Use a pin to press the reset button on BACK and hold for 3 seconds until the Green LED flashes 使⽤用PIN針按住電池匣內的reset鍵,直 到LED燈閃爍為⽌止 4 You will need to enter PIN code that combines digits and letters.
5 You can place ∑Motion in detectable place or stick it on the wall by using holder and adhesive tape 你可使⽤用⽀支架配件安裝⾄至牆⾯面上 7
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.