Issue department:R&D Division Product Function instruction CB.34.33.01 Date: Author: 2019-11-17 Jarek No:CB3433A Version: 1.0 Page 1 of 5 CB3433A Function instruction 1.
Issue department:R&D Division Product Function instruction CB.34.33.01 Date: Author: 2019-11-17 Jarek No:CB3433A Version: 1.0 Page 2 of 5 2.Function Picture 3.Interface function description3.1.HEAD ACTUATOR Connect to head actuator,control by remote single: Click head up button on the remote, head actuator moves out, stop when released; Click head down button,head actuator moves in, stop when released; This function takes effect only by pressing the corresponding button on the remote. 3.2.
Issue department:R&D Division Product Function instruction CB.34.33.01 Date: Author: 2019-11-17 Jarek No:CB3433A Version: 1.0 Page 3 of 5 3.3.LUMBAR ACTUATOR Connect to foot actuator,control by remote single: Click Lumber up button,foot actuator moves out,stop when released; Click Lumber down button,foot actuator moves in,stop when released; This function takes effect only by pressing the corresponding button on the remote. 3.4.
Issue department:R&D Division Product Function instruction CB.34.33.01 Date: Author: 2019-11-17 Jarek No:CB3433A Version: 1.0 Page 4 of 5 If fails, repeat all the processes above; 3.8.SYNC port Connect with the same other Control box or Other accessories; 3.9.underbed light-RGB Click button of underbed light, turns on(or change) the underbed light, switch the status once when click once; This function takes effect only by pressing the corresponding button on the remote. 3.10.
Issue department:R&D Division Product Function instruction CB.34.33.01 Date: Author: 2019-11-17 Jarek No:CB3433A Version: 1.0 Page 5 of 5 ISED RSS Warning: This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.