598994-01,370511 TYPE2 1/5/06 10:44 AM Page 1 Instruction Manual 120 Volt CONVERTIBLE MULCHING MOWER Model No. 900.370511 WARNING: • • Before using this product, • read this manual and follow • all its Safety Rules and • Operating Instructions. • Sears, Roebuck and Co., Hoffman Estates, Safety Assembly Operation Maintenance Parts List Español Pág. 17 IL 60179 USA www.sears.com/craftsman Form No. 598994-01 JAN.
598994-01,370511 TYPE2 1/5/06 10:44 AM Page 2 TABLE OF CONTENTS Warranty Safety Instructions Maintenance Assembly Operation Maintenance Schedule Product Specifications Service and Adjustments Storage Troubleshooting Illustrated Parts List Español 2 2 4 5 7 12 13 13 13 14 15,16 17 WARRANTY LIMITED TWO YEAR WARRANTY ON CRAFTSMAN POWER MOWER For two years from date of purchase, when this Craftsman Power Mower is maintained, lubricated, and tuned up according to the operating and maintenance instruction
598994-01,370511 TYPE2 1/5/06 10:44 AM Page 3 • Mow only in daylight or good artificial light. • Do not plug mower in until it is ready to be used. • Protect your lungs. Wear a face or dust mask if mowing operation is dusty. • Remove all adjusting wrenches from mower before turning it on. TRAINING: • Read this operator’s manual carefully. Become familiar with the controls and know how to operate your mower properly. Learn how to quickly stop mower. • Avoid dangerous environments.
598994-01,370511 TYPE2 • • • • • • • • • • • 1/5/06 10:44 AM Page 4 iv) Repair any damage before restarting and operating the lawn mower. Do not operate your mower if it vibrates abnormally. Excessive vibration is an indication of damage; stop the motor and safely check for the cause of vibration. Repair as required. Do not run the motor indoors. Never cut grass by pulling the mower towards you. Mow across the face of slopes, never up and down or you might lose your footing.
98994-01,370511 TYPE2 1/5/06 10:44 AM Page 5 SJTW-A or SJTOW-A. An extension cord must have adequate wire size (AWG or American Wire Gauge) for safety, and to prevent loss of power and overheating. The smaller the gauge number of the wire, the greater the capacity of the cable; that is, 16 gauge has more capacity than 18 gauge. When using more than one extension to make up the total length, be sure each individual extension contains at least the minimum wire size.
598994-01,370511 TYPE2 1/5/06 10:44 AM Page 6 CAUTION: Do not lift the lawnmower off the ground by holding the height adjustment finger grip. • Remove the Grasscatcher frame, Grassbag and cardboard fillers. • Remove the mower from the carton and place all four wheels on the ground or floor. • Check the carton thoroughly and make sure there are no loose parts. To Unfold Handle Raise the handle section into place and secure by tightening the two knobs. See figure below.
598994-01,370511 TYPE2 1/5/06 10:44 AM Page 7 OPERATION KNOW YOUR MULCHING MOWER READ THIS OWNER’S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR MULCHING MOWER. Compare the illustrations with your mulching mower to familiarize yourself with the location of various controls and adjustments. Save this manual for future reference. These symbols may appear on your mulching mower or in literature supplied with the product. Learn and understand their meaning.
598994-01,370511 TYPE2 1/5/06 10:44 AM Page 8 • To raise or lower the cutting height, rest the palm of your hand on the palm rest and with your fingers, squeeze upward on the finger grip and hold. TO STOP MOWER To stop mower fully release your grip on the operator presence control switch. ATTACHING EXTENSION CORD TO MOWER Palm Rest DO NOT connect the extension cord to power source until you have finished reading this manual and you are ready to start mowing.
598994-01,370511 TYPE2 1/5/06 10:44 AM Page 9 out so that you can grab it with your other hand. Pull the lever back to turn the unit on and hold it against the mower handle to keep it running. To turn the mower off, just release the lever. The spring loaded “SNAP ACTION” lever will quickly turn the mower off. WARNING: • For your own safety DO NOT use this mower without either the grasscatcher or mulch insert in operating position.
598994-01,370511 TYPE2 1/5/06 10:44 AM Page 10 is overgrown it will be necessary to increase the cutting height to reduce the pushing effect and reduce overloading the motor. For extremely heavy mulching make narrower cuts and mow slowly. • Certain types of grass and grass conditions may require that an area be mulched a second time to completely hide the clippings. When doing a second cut, mow across or perpendicular to the first cut path.
598994-01,370511 TYPE2 1/5/06 10:44 AM Page 11 • Place square steel washer on shaft so that flat sides of hole in washer are parallel with flat sides of shaft. • Place blade nut on shaft. Make sure all parts stay aligned. Position wood to keep shaft from turning. Securely tighten blade nut clockwise to 20-30 ft. lbs.
598994-01,370511 TYPE2 1/5/06 10:44 AM Page 12 • Check balance of blade. See instructions for blade balancing. • After blade is sharpened and balanced replace blade on mower and tighten securely. Vise TO BALANCE BLADE • Check balance of blade by placing center hole in blade over a nail or screwdriver shank, clamped horizontally in a vise. If either end of the blade rotates downward, file that end. Blade is properly balanced when neither end drops.
598994-01,370511 TYPE2 1/5/06 10:44 AM Page 13 PREVENTING CORROSION • Fertilizers and other garden chemicals contain agents which greatly accelerate the corrosion of metals. If you mow in areas where fertilizers or chemicals have been used, the mower should be cleaned immediately after use. • CAUTION: DO NOT pour or spray water on the mower. • Do not store the tool on or adjacent to fertilizers or chemicals. Such storage can cause rapid corrosion.
598994-01,370511 TYPE2 1/5/06 10:44 AM Page 14 TROUBLESHOOTING CHART PROBLEM CAUSE Does not start CORRECTION • Power cord is not properly plugged in • No power from outlet • Blade does not rotate freely or mower deck is clogged • Check extension cord attachment at both mower and outlet ends. • Check breaker or fuse. • Unplug power cord, turn mower on its side and check blade. Make sure it is free to rotate. Also check for clogging.
598994-01,370511 TYPE2 1/5/06 10:44 AM diagram 15 Page 15
598994-01,370511 TYPE2 1/5/06 10:44 AM parts page 16 Page 16
598994-01,370511 TYPE2 1/5/06 10:44 AM Page 17 CONTENIDO Garantía Reglas de seguridad Mantenimiento Ensamblaje Operación Itinerario de mantenimiento Especificaciones del producto Servicio y ajustes Almacenaje Solución a problemas frecuentes Lista de partes ilustrada 17 17 19 20 22 27 28 28 28 29 30, 31 GARANTIA GARANTIA LIMITADA POR DOS AÑOS EN LA PODADORA CRAFTSMAN Sears reparará sin cargos cualquier defecto que se presente en materiales o mano de obra de esta podadora Craftsman, durante dos años a
598994-01,370511 TYPE2 1/5/06 10:44 AM Page 18 • Retire las herramientas de ajuste antes de encender la podadora. ENTRENAMIENTO • Lea cuidadosamente este manual del operador. Familiarícese con los controles y sepa a operar su podadora apropiadamente. Aprenda a apagar su podadora rápidamente. • Evite ambientes peligrosos. No utilice su podadora bajo la lluvia ni en lugares mojados. No la opere en atmósferas gaseosas o explosivas.
598994-01,370511 TYPE2 • • • • • • • • 1/5/06 10:44 AM hacia usted. Pode en sentido perpendicular a las pendientes; nunca hacia arriba y hacia abajo. Tenga precaución extrema cuando cambie de dirección en las pendientes. No pode en pendientes muy pronunciadas — conserve bien apoyados los pies. Nunca opere la podadora sin que las guardas apropiadas, las placas u otros dispositivos de seguridad estén en su sitio. No fuerce la podadora.
598994-01,370511 TYPE2 1/5/06 10:44 AM PRECAUTION: Repare o reemplace los cordones eléctricos dañados. Utilice solamente refacciones Craftsman idénticas cuando haga servicio a cualquier herramienta. Page 20 CUCHILLA DE REPUESTO La cuchilla de repuesto es la parte #33243 y está a su disposición en las tiendas y centros de servicio Sears. CLAVIJA POLARIZADA Esta podadora cuenta con una clavija polarizada (con una pata más ancha que la otra) para reducir los riesgos de choque eléctrico.
598994-01,370511 TYPE2 Perillas Knobs 1/5/06 10:44 AM Page 21 B Mango Handle Clip Presilla INSTALACION DE LA BOLSA PARA PASTO ENSAMBLAJE DE LA BOLSA PARA PASTO • Por debajo y en medio de los mangos de la podadora, levante la puerta trasera de descarga hasta que quede en posición vertical y sujétela. (Observe la Fig. A) • Deslice la bolsa para pasto en el armazón. (Observe la Fig. A.) • La bolsa para pasto tiene unas presillas cosidas alrededor de la abertura. • Saque el inserto de recorte.
598994-01,370511 TYPE2 1/5/06 10:44 AM Page 22 OPERACION CONOZCA SU PODADORA LEA ESTE MANUAL DEL PROPIETARIO Y LAS REGLAS DE SEGURIDAD ANTES DE OPERAR SU PODADORA. Compare las ilustraciones con su podadora para familiarizarse con la localización de los diferentes controles y ajustes. Conserve este manual para referencias futuras. Estos símbolos pueden aparecer en su podadora o en la literatura que se proporciona con el producto. Aprenda y comprenda su significado.
598994-01,370511 TYPE2 1/5/06 10:44 AM Page 23 coloque la palma de su mano sobre el descanso para la palma y oprima el asa para los dedos con éstos, sujétela. PARA APAGAR LA PODADORA Para apagar la podadora, suelte completamente el interruptor de control en presencia del operador. Apoyo para la palma UNION DE LA EXTENSION AL CORDON ELECTRICO DE LA PODADORA Indicador NO conecte la extensión a la toma de corriente hasta que haya terminado de leer este manual y empiece a podar.
598994-01,370511 TYPE2 1/5/06 10:44 AM de la podadora para conservarla en funcionamiento. para pagar la podadora, simplemente libere la palanca. La palanca (con acción de resorte) apagará la podadora inmediatamente. Page 24 ADVERTENCIA: • Por su propia seguridad NO utilice esta podadora sin que la bolsa para pasto o el inserto recortador estén en posición de operación. • No opere la podadora si la puerta trasera no está bajo la tensión del resorte.
598994-01,370511 TYPE2 1/5/06 10:44 AM Page 25 empuje y disminuir la sobrecarga del motor. Para podados extremadamente pesados haga cortes angostos y haga movimientos lentos. espere a que la cuchilla se detenga por completo. Desconecte el cordón eléctrico y gire la podadora de lado. Elimine el pasto acumulado en la zona de la cuchilla con un objeto similar a una vara. Tenga cuidado con los filos de la cuchilla.
598994-01,370511 TYPE2 1/5/06 10:44 AM Page 26 • Coloque la roldana cuadrada de acero en el eje de manera que los lados rectos de la roldana queden paralelos a los lados planos del eje. REMOCION DE LA CUCHILLA • ¡Libere la palanca del interruptor para apagar la podadora, espera a que la cuchilla se detenga y desconecte la podadora! • Coloque la tuerca de la cuchilla en el eje. Asegúrese que todas las partes estén alineadas.
598994-01,370511 TYPE2 1/5/06 10:44 AM • Vuelva a colocar la cuchilla en la podadora y apriete con firmeza. Prensa Page 27 BALANCEO DE LA CUCHILLA • Verifique el balance de la cuchilla colocando la perforación central sobre un clavo o sobre el vástago de un destornillador sujetado en una prensa. Si cualquiera de los extremos gira hacia abajo, afile ese extremo. La cuchilla está balanceada correctamente cuando ninguno de los extremos cae.
598994-01,370511 TYPE2 1/5/06 10:44 AM Page 28 CUIDADO DE LA CUCHILLA EVITE LA CORROSION Para obtener mejores resultados, la cuchilla de la podadora debe estar afilada. Reemplace las cuchillas dobladas o dañadas. • Los fertilizantes y otros productos químicos para jardinería contienen agentes que aceleran la corrosión de los metales. Si poda en áreas en donde se han utilizado fertilizantes u otros químicos, la podadora deberá ser limpiada inmediatamente.
598994-01,370511 TYPE2 1/5/06 10:44 AM Page 29 TABLA PARA SOLUCION DE PROBLEMAS FRECUENTES PROBLEMA CAUSA CORRECCION No enciende •El cable no está bien conectado •No hay corriente en la toma •La cuchilla no gira libremente, o la cubierta de la podadora está tapada •Revise la instalación del cable de extensión en ambos extremos, en la podadora y en la toma de corriente •Revise el interruptor o los fusibles •Desconecte el cable, coloque la podadora de lado y revise la cuchilla.
598994-01,370511 TYPE2 1/5/06 10:44 AM 30 Page 30
598994-01,370511 TYPE2 1/5/06 10:44 AM 31 Page 31
598994-01,370511 TYPE2 1/5/06 10:44 AM 32 Page 32