ENGLISH ASSEMBLY, cont'd OPERATION Adjusting the Seat 1. Pushiness and hold the seat adjustment lever to adjust the seat position. 2. Slide seat forward ot rearward to desired position. 3, Release the adjustment lever Ensure seats locked into position before operation.
OPERATION, cont'd 5] Power Take-Off (PTO) Electric PTG The PIO switch operates the electric PIO clutch mounted oa the bottom of the engine crankshaft. Pull the switch knob upward to engage the PIO clutch, of push the knob downward to disengage the clutch. The PTO switch must be in the “OFF position when starting tie engine. 6} Ignition Switch WARNING: Tevet leave a running machine unattended. Always disengage PTO, set parking brake, stop engine, and veniremen key to prevent unintended starting.
ENGLISH OPERATION, cont'd Before Operating Tractor + Before operation, refer to Maintenance Schedule chart located in this manual for regularly scheduled service tees, + This engine Is certified to operate only an clean, fresh, unleaded gasoline Fill only with clean, fresh, unleaded gasoline with 4 tempura sticker octane raising of 87 or higher Do not use gas cling deft over from the previous season, to minimize gum deposits fa the fuel system.
OPERATION, cont'd NOTE: Lap bar dive control levers must be moved fully inward before pushing forward or backward to ensure brakes are fully disengaged. Parking the tractor on uneven terrain ora hill may cause the brakes to bind and nol release full, In this case the tractor wil nat drive when the haphazard drive control levers are moved. if this happens, move the lap bar drive control lever in the opposite direction slightly to ake the load off the brakes and allow them to release fully.
ENGLISH OPERATION, cont'd Stopping the Tractor 1. Move both lap bar drive control! levers to the retrain position to spat the motion of the reactor, 2. Push the PTO downward to the OFF position. 3. Use the deck lift knot/handle to raise the deck to its highest position.
SERVICE AND MAINTENANCE, cont'd ENGLISH After Firsts Hours Sea Engine Manuel Every 100 Hours Every 200 Hours Porto Storing Before Each use) Every 10|Every 25 Every 50] Hours | Hours | Hours Check TOPS Hardware & Seat Brit Assembly v Check Mower Blade Stop Time v Inspect & Lube Beck Wheels.
ENGLISH SERVICE AND MAINTENANCE, cont'd in addition to dealing the actor before operating and storing, do not attempt ie mow unusually tall grass cr) of highhanded, dry grass fog, pasture) of piles of dry deaves, Dry grass or leaves may contact the engine exhaust and/or bulls up on the mower deck presenting a potential fie hazard, suing the Tractor Allow the machine to cool in an open ares for at least five minutes before storing.
SERVICE AND MAINTENANCE, cont'd NOTE: Using 2 pressure washer ar garden hose is not recommended for clearing the doctor other than to clean the underside of the deck it may course damage to electrical components, spindles, pulleys, bearings or the engine. The use of water will result in shortened life an recherche serviceability. 4. Fully charge the battery, thee: disconnect the negative cable at the battery to present possible discharge. Recharge the battery periodically when In storage.
ENGLISH SERVICE AND MAINTENANCE, cont'd Service Electrical System Fuse Is Installed to protect the tractors electrical system firm carnage consed by excessive amperage, Always use the same capably use for replacement. F the electrical system dues not function, check for a blown: use.
EN GUSH SERVICE AND MAINTENANCE, cont'd 3. Re-castoff the applicable hardware for the actor, n reverse order of the 7. Place the bet around the der pulleys removed in Step 4 with the *V* side facing io, removal process: ard no Inks or twists along the run of the belt. Once in place, loosely reinstall the a. Install the hanger rod clevis ends af the deck height adjust rods removed ia Step 8 idler at hardware. of Deck Removal and secure with the bow-Ue pins previously removed. 8.
ENGLISH SERVICE AND MAINTENANCE, cont'd Troubleshooting WARNING: Before perforating any type of malitenance/service, disengage afl controls and stop the lien, Walt unit all moving parts have come toa complete stop, Disconnect spark plight wire and ground it against the engine to prevent unintended starting. Always wear salty glasses daring operation or while performing any adjustments or repairs, This section addresses miner service Issues.