ASSEMBLY INSTALLING THE CUTTING HEAD SHIELD (DXGST227CS) WARNING: To prevent serious personal injury, never operate the unit without the cutting head shield in place, 1. Remove the wing nut and washer from the cutting head shield. 2. insert the short tab {the one without a hole on the aunt bracket into the slot an the cutting head shield {Fig. 1). 3. Rotate the cutting head shield counterclockwise to align the hole on the cutting head shield with the hole on the mount bracket Fig. .
INSTALLING AND REMOVING THE ATTACHMENT The couplet enables the use of various optional attachments. understand the manual that came with the attachment. g WARNING: Before using any attachment, read and Folio all safety information contained within, damage to the unit, shut the unit off before removing or installing an attachment. g WARNING: To avoid serious personal injury and Installing the Attachment 1. Remove the hanger cap from the attachment.
INSTALLING AND ADJUSTING THE HANDLE Installing the Handle 1. 6. Press and hold the handle bass against the underside of the paper shaft housing (Fig. 8). . Press the handle top onto the handle base until they snap together (Fig. 8). . Insert the boils (x4) into the holes {x4) (Fig. 8). . Tighten the bolts, but do not titan them completely. Use a {4 rm) Allen wrench. . Hold the unit in the operating position (Fig. 17). Move the handle up or down the upper shaft housing to a comfortable location {Fig.
ASSEMBLING AND USING THE SHOULDER STRAP {OPTIONAL} Assembling the Shoulder Strap 1. Push the strap up through the center slot in the buckle {Fig. 10, 2. Bend the strap over and push i down through the lower slot in the buckle (Fig. 10} Using the Shoulder Strap 1. Put the shoulder strap over the operator's head and onto the left shoulder {Fig. 12} 2. Start the unit, Refer to Starting and Stopping. . Snap the clip onto the shoulder strap / shames loop (Fig. 1), 4.