Installation Guide

Need Help?
Call 1-855-971-1123
ASSEMBLY TOOLS REQUIRED
• 5/32-inch (4 mm) Allen wrench (included)
DIDN’T START?
Repeat the starting
instructions.
If the unit still fails to start,
refer to the operator’s
manual for additional
starting and troubleshooting
information.
Crouch in the starting position. SQUEEZE and HOLD the
throttle lockout and the throttle
control for ALL further steps.
Pull the starter rope with a
controlled and steady motion 5
times.
50:1
Mix thoroughly in a separate fuel
can:
– 2.6 fl. oz. of 2-cycle engine oil
– 1 gallon of fresh unleaded
gasoline (less than 30 days old)
NOTE: Do not mix directly in the
unit fuel tank.
A
B
Move the choke lever to
Position B.
Position the unit with the fuel cap
facing up. Slowly remove the fuel
cap. Fill the fuel tank. Reinstall
the fuel cap. Move the unit at
least 30 ft. (9.1 m) from the fuel
container and the fueling site
before starting the engine.
8
9
3 4
5
6
Read the operator’s manual
thoroughly before operating
the unit. Follow all warnings and
safety instructions. This fast
guide is intended as a reference
for users that have already read
the operator's manual and are
familiar with the necessary safety
precautions.
Align the release button with the
guide recess. Push the
attachment straight into the
coupler until the release button
snaps firmly into the primary
hole. Turn the knob clockwise to
tighten the coupler.
Hold the unit in the operating
position. Move the handle up or
down the upper shaft housing to
a comfortable location. Make
sure the handle is positioned
beyond the end of the safety
label. Tighten the bolts until the
handle is secure.
Press and hold the handle base
against the underside of the
upper shaft housing. Press the
handle top onto the handle base
until they snap together. Insert
the bolts (x4) into the holes (x4).
Tighten the bolts, but do not
tighten them completely. Use a
5/32-inch (4 mm) Allen wrench.
Remove the hanger cap from the
attachment. If present, remove
the gray spacer from the coupler.
Turn the knob counterclockwise
to loosen the coupler.
1
6
4 5
7
A
B
Move the choke lever to
Position A.
2
Pull the starter rope with a
controlled and steady motion 5
times to start the engine.
Allow the engine to warm up for
60 seconds. The unit may be
used during this time.
7
Slowly press and release the
primer bulb 10 times.
1
STARTING
778-18400 / 00 01/20
Starter Rope Grip
Fuel Cap
Throttle Control
On / Off Switch
Choke Lever
Primer Bulb
Handle
Throttle Lockout
Coupler
Upper Shaft
Housing
Insert the short tab (the one
without a hole) on the mount
bracket into the slot on the cutting
head shield. Rotate the cutting
head shield counterclockwise.
Insert the square bolt into the hole
underneath the cutting head shield.
Push the square bolt through the
cutting head shield and mount
bracket. Place the washer and
wing nut onto the square bolt.
Tighten the wing nut securely.
2 3
ASSEMBLY
Lower Shaft
Housing
Cutting Head Shield
IMPORTANT: READ THE OPERATOR’S MANUAL THOROUGHLY AND FOLLOW
THE SAFE OPERATION PRACTICES WHILE OPERATING THE UNIT.
Lea la traducción en Español en el manual.