Instructions / Assembly

TO TIGHTEN:
WITH RATCHET CLOSED, THREAD STRAP THROUGH THE SLOT
IN THE CENTER OF THE RATCHET DRUM.
TO TIGHTEN, RAISE AND LOWER RATCHET HANDLE; DO NOT
OVERTIGHTEN. (MAKE SURE TO HAVE A MINIMUM OF 2 FULL
WRAPS OF WEBBING AROUND THE DRUM.)
PULL WEBBING THROUGH, REMOVING THE SLACK.
KEEP RATCHET IN CLOSED POSITION TO LOCK.
READ ALL WARNINGS CAREFULLY AND COMPLY WITH ALL WARNINGS.
FAILURE TO DO SO MAY RESULT IN DAMAGE TO THIS PRODUCT, PERSONAL PROPERTY AND/OR PERSONAL INJURY.
*DO NOT EXCEED THE WORKING LOAD LIMIT OF THE STRAP; TAKING INTO ACCOUNT THE STRAP, THE LOAD, THE VEHICLE ANCHOR POINTS, STRAP CONFIGURATION AND ANGLE, ETC.
TO RELEASE:
PULL UP ON THE RELEASE BAR AND HOLD.
GRAB WEBBING AND PULL AWAY FROM THE RACTCHET HEAD
TO RELEASE.
WITH THE RELEASE PULLED UP, PUSH FORWARD UNTIL THE
RATCHET IS COMPLETELY FLAT AND OPEN.
OPERATING INSTRUCTIONS
DXBC30002 / DXBC30004
RATCHET STRAP
www.DEWALTSTRAPS.com
21
21
43
3