Product Manual

IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR ANY DEWALT TOOL,
CALL US AT: 1800 654 155 (Aust) or 09 526 2556 (NZ).
The batteries in your new battery pack are not fully charged! First read the safety
instructions, then follow charging notes and procedures.
SAFETY INSTRUCTIONS FOR POWER TOOLS
When using power tools, always observe the safety regulations applicable in your
country to reduce the risk of fire, electric shock and personal injury. Read the following
safety instructions before attempting to operate this product. Keep these instructions in
a safe place.
General Safety Rules
WARNING! Read all instructions. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury. The term “power tool” in
all of the warnings listed below refers to your mains operated (corded) power tool or
battery operated (cordless) power tool.
SAVE THESE INSTRUCTIONS
Electrical Safety
The electric motor has been designed for one voltage only. Always check that the
power supply corresponds to the voltage on the rating plate. 240 V AC means your
tool will operate on alternating current. As little as 10% lower voltage can cause loss
of power and can result in overheating. All DEWALT tools are factory tested; if this tool
does not operate, check the power supply. Your DEWALT tool is double insulated,
therefore no earth wire is required.
• Young children and the infirm. This appliance is not intended for use by young
children or infirm persons without supervision. Young children should be super-
vised to ensure that they do not play with this appliance.
• Replacement of the supply cord. If the supply cord is damaged, it must be
replaced by the manufacturer or an authorised D
EWALT Service Centre in order to
avoid a hazard.
READ ALL INSTRUCTIONS
• Do not incinerate the battery pack even if it is severely damaged or is completely
worn out. The battery pack can explode in a fire.
• A small leakage of liquid from the battery pack cells may occur under extreme
usage or temperature conditions. This does not indicate a failure. However, if the
outer seal is broken and this leakage gets on your skin:
a. Wash quickly with soap and water.
b. Neutralize with a mild acid such as lemon juice or vinegar.
c. If battery liquid gets into your eyes, flush them with clean water for a minimum
of 10 minutes and seek immediate medical attention. (Medical Note: The liquid
is 25–35% solution of potassium hydroxide.)
• Charge the battery packs only in DEWALT chargers.
• DO NOT splash or immerse in water or other liquids.
• Do not store or use the tool and battery pack in locations where the temperature
may reach or exceed 105°F (40˚C) (such as outside sheds or metal buildings in
summer).
• DO NOT probe pack with conductive objects.
• Maintain clean and open vent holes.
NOTE: Review and observe all of the Important Charging Notes in the DEWALT charger
instruction manual.
DANGER: Never attempt to open the battery pack for any reason. If battery pack
case is cracked or damaged, do not insert into charger. Electric shock or electrocution
may result. Damaged battery packs should be returned to service center for recycling.
CAUTION: Battery pack must be securely attached to tool. If battery pack is
detached, personal injury may result.
NOTE: Battery storage and carrying caps are provided for use when-
whenever the battery is out of the tool or charger. Remove cap before
placing battery in charger or tool.
WARNING: Do not store or carry battery so that metal objects
can contact exposed battery terminals. For example, do not place
battery in aprons, pockets, tool boxes, product kit boxes, drawers, etc.,
with loose nails, screws, keys, etc. without battery cap. Transporting batteries can
possibly cause fires if the battery terminals inadvertently come in contact with
conductive materials such as keys, coins, hand tools and the like. The US
Department of Transportation Hazardous Material Regulations (HMR) actually prohibit
transporting batteries in commerce or on airplanes (i.e., packed in suitcases and carry-
on luggage) UNLESS they are properly protected from short circuits. So when
transporting individual batteries, make sure that the battery terminals are protected and
well insulated from materials that could contact them and cause a short circuit.
The RBRC™ Seal
The RBRC™ (Rechargeable Battery Recycling Corporation) Seal on
the nickel-cadmium battery (or battery pack) indicates that the costs
to recycle the battery (or battery pack) at the end of its useful life
have already been paid by DEWALT. In some areas, it is illegal to
place spent nickel-cadmium batteries in the trash or municipal solid
waste stream and the RBRC program provides an environmentally
conscious alternative.
RBRC™ in cooperation with DEWALT and other battery users, has established pro-
grams in the United States to facilitate the collection of spent nickel-cadmium batteries.
Help protect our environment and conserve natural resources by returning the spent
nickel-cadmium battery to an authorized DEWALT service center or to your local retailer
for recycling. You may also contact your local recycling center for information on
where to drop off the spent battery.
RBRC™ is a registered trademark of the Rechargeable Battery Recycling Corporation.
GUARANTEE
Full One Year Warranty
DEWALT heavy duty industrial tools are warranted for one year from date of purchase.
We will repair, without charge, any defects due to faulty materials or workmanship.
Please return the complete unit, transportation prepaid, to any DEWALT Service Centre,
or any authorised service station.
This warranty does not apply to:
• Accessories
• Damage caused where repairs have been made or attempted by others
• Damage due to misuse, neglect, wear and tear, alteration or modification.
30 DAY NO RISK SATISFACTION GUARANTEE
If you are dissatisfied with any D
EWALT power tool, for any reason, simply return it to
the point of purchase with your sales receipt within 30 days for a replacement unit or
a full refund.
FREE WARNING LABEL REPLACEMENT: If your warning labels become illegible or are
missing, call 1800-654-155 for a free replacement.