D25122(K) D25123(K) D25124(K) D25213(K)
English 6 Copyright DE WALT 2
9 7 5 4 5 4 1 6 11 10 D25213 9 7 3 6 1 11 10 2 D25123 8 4 A D25122 D25124 3
5 4 6 B1 5 B2 7 4 12 C 10 9 D 4 E 11
3 3 F1 F2 8 6 13 G 8 H 5
ENGLISH HEAVY DUTY ROTARY HAMMER DRILL D25122(K)/D25123(K)/D25124(K)/D25213(K) Congratulations! You have chosen a DEWALT tool. Years of experience, thorough product development and innovation make DEWALT one of the most reliable partners for professional power tool users.
ENGLISH 7
ENGLISH Package contents The package contains: 1 Heavy duty rotary hammer drill 1 Side handle 1 Depth adjustment rod 1 Kitbox (K-models only) 1 Keyless chuck (D25124) 1 Instruction manual Check for damage to the tool, parts or accessories which may have occurred during transport. Take the time to thoroughly read and understand this manual prior to operation.
ENGLISH Your DEWALT tool is double insulated in accordance with IEC60745; therefore no earth wire is required. D25123K/D25124K/D25213K (fig. B2) The tool can be used in the following operating modes: Using an extension cable If an extension cable is required, use an approved extension cable suitable for the power input of this tool (see technical data). The minimum conductor size is 1.5 mm2. When using a cable reel, always unwind the cable completely. Also refer to the table below.
ENGLISH We recommend to use professional accessories only. Clean and grease the bit shank. Insert the bit shank into the tool holder (6). Push the bit down and turn it slightly until it fits into the slots. Pull on the bit to check if it is properly locked. The hammering function requires the bit to be able to move axially several centimetres when locked in the tool holder. To remove a bit pull back the tool holder locking sleeve (12) and pull out the bit. Fitting the side handle (fig.
ENGLISH Be aware of the location of pipework and wiring. Apply only a gentle pressure to the tool (approx. 5 kg). Excessive force does not speed up drilling but decreases tool performance and may shorten tool life. Do not drill or drive too deep to prevent damage to the dust cover. Always hold the tool firmly with both hands and ensure a secure stance (fig. H). Always operate the tool with the side handle properly mounted. Switching on and off (fig.
ENGLISH Insert the appropriate screwdriver bit. When driving slotted head screws always use bits with a finder sleeve. Gently press the variable speed switch (1) to prevent damage to the screw head. In reverse (LH) rotation the tool speed is automatically reduced for easy screw removal. When the screw is flush with the workpiece, release the variable speed switch to prevent the screw head from penetrating into the workpiece. D 25123K/D25124K/D25213K - Chipping and chiselling (fig.