Device Solutions Collector & Sensor Installation Instructions Revision History: PRELIMINARY
FCC Caution: Changes or modifications not expressly approved by Device Solutions could void the user’s authority to operate this equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
g. Move the Collector and/or Sensor until the Sensor displays a good signal condition for at least 5 consecutive seconds h. Repeat c through g for each sensor i. Disable "install mode" for the Collector by pressing the button on the collector again (if this step is forgotten the collector will exit install mode in one hour) j. Turn off each Sensor by removing the 9 volt battery 3. Loosen the nut from the cable restraint shown above 4. Pass the transducer wires through the cable restraint 5.
Appendix: Ashcroft Pressure Transducer Installation Bare wire (shield drain wire) from the transducer is unused.