User's Manual

ManualsBrandsDesignTech International ManualsElectronicsSecurity R/C Receiver

Mounting the Driveway Sensor:Mounting the Driveway Sensor:

Mounting the Driveway Sensor:

The stake comes in two parts. Connect the two

stakes by pushing them firmly together.

2. Mount the Driveway Monitor stake on the side of the driveway.

3. Once the stake is in the ground, mount the driveway sensor onto the stake using

the two screws as shown in the picture below. Do not pound the stake into the

ground with the sensor attached.

Another option is to mount the sensor to a fence, tree, or post. The

higher the sensor is mounted off the ground, the better the range. The

object to which you mount the driveway sensor must not move in the

wind to avoid false triggers on windy days. Do not mount the sen-

sor to metal objects.

Page 1 Driveway Monitor 30074

Driveway Monitor 30074 Page 2

Installation Instructions

Wireless Driveway Monitor

Model # 30074

v 1.4

7955 Cameron Brown Court • Springfield, Virginia 22153 USA

www.designtech-intl.com

Whenever a vehicle drives by, you will be notified in the house.

If you have any problems with:

• Getting the system to function,

• Getting the system to work from the end of your

driveway,

• Making the volume higher or lower ,

• Using 2 or more sensors or receivers with

your system,

• or buying additional accessories

Please refer to the separate REFERENCE GUIDE.

Installing Batteries in the Driveway Sensor:Installing Batteries in the Driveway Sensor:

Installing Batteries in the Driveway Sensor:

1. Pop the back of the Driveway Sensor off using a flat

blade (slotted) screwdriver.

2. Insert two "D" alkaline batteries (not included). Note the

positive and negative battery orientation

3. Close the case back to-

gether tightly. The O-

ring should provide a

water resistant seal.

Setting Up the Driveway Monitor Receiver:Setting Up the Driveway Monitor Receiver:

Setting Up the Driveway Monitor Receiver:

Straighten the 9-inch antenna wire which comes out of the top of the case.

The antenna should be vertical.

Plug in the AC adapter on the side of

the receiver. The receiver will chirp and

the alert light will flash red then stay

green.

Testing the System Prior to InstallationTesting the System Prior to Installation

Testing the System Prior to Installation

The sensor and receiver are factory set to a unique code. Before installing

the sensor outside, test the unit by rotating the driveway sensor (rotate the

sensor more than 5 feet away from the receiver). (If you listen carefully, you

will hear the sensor softly chirp like a cricket when the unit is transmitting a

signal.) The receiver will chime twice and the ALERT light will flash RED for

15 minutes.

If the receiver does not chime or the red ALERT light does not come on

during this test - refer to the Trouble Shooting section of the Reference

Guide.

O-ring

Antenna

Alert &

Power light

- - - -Main Street ----

Place sensor

25+ ft. from

main street

and 5 ft. or

less from

driveway

Driveway

25+

ft.

5 ft.

less

This device complies with FCC Rules Part 15. Operation is subject to two conditions: 1) This device may not cause harmful interference, and 2)

it must accept any interference received, including that which may cause undesirable operation.

FCC ID: ELGDWMTX & ELGSHR1

DOC: _____________

User is cautioned that changes or modifications not expressly approved by DesignTech could

void the user's authority to operate this equipment.

Covered under US Patent Numbers: 4,851,775 & 5,239,264