V1.
Congratulations on your purchase of the Smart Entrytm from DesignTech. 1. Mounting and Connecting the module: Smart Entrytm Protects You: Lock and unlock your doors & trunk by remote control. Optional Features Include: Car Locator Remote Panic/Rescue alarm Turn on your headlights by remote control. Screws or cable ties may be used for mounting the module in the driver's left kick panel area. We recommend mounting after everything has been completed and tested fully.
negative transistor output. In most cases you will need to use an external relay (not supplied) when hooking up this wire. See Page 8 for a detailed hook-up using a relay. 6. BROWN This is used for Dome Light activation. This optional wire can control a relay to activate the dome light for 25 seconds after the doors are unlocked with the transmtiter. This is a (-400mA) negative transistor output. This wire must drive an external relay. 7. BLUE Horn/Siren.
12. TRYING OUT THE UNIT: 3. Always keep one window rolled down to avoid locking yourself out of the vehicle. Your transmitter has already been factory coded to the Smart Entrytm . (If it does not trigger any of the following functions, and you have already checked your connections, follow the steps for Transmitter Code Learning at the end of the manual.) Generally, the transmitter button should be held down until the Smart Entrytm unit responds with the desired feature.
14. Example of optional Trunk hookup using an external relay: Take a relay with 10 amp or higher capacity and a 12 volt coil. Locate the push button for the trunk (usually in the glove compartment). You will notice two wires behind this push button switch. Connect the Smart Entry's Green/White Trunk wire to one side of the relay coil and constant +12 volts to the other side of the coil.
LIMITED WARRANTY OTHER ACCESSORIES A. B. C. Extra transmitters for more than one user in the family. Up to four transmitters can be used with each Smart Entrytm. Garage Door Receiver Unit will allow Your Smart Entrytm transmitter to operate an electric garage unit. You can remotely control your vehicle with our AutoCommand model 20022. Simply pushing the lock button twice on your Smart Entry will start your vehicle.