Installation Sheet

2 LIGHT 13" WHITE CHANNEL LIGHT SKU#501452
ASSEMBLY / INSTALLATION INSTRUCTIONS
Please read carefully and save these instructions, as you may need them at a later date.
CAUTION
Turn off the main power at the circuit breaker before installing the fixture, in order to prevent possible shock.
GENERAL
All electrical connections must be in accordance with local and National Electrical Code (N.E.C.) standards.
If you are unfamiliar with proper electrical wiring connections obtain the services of a qualified
electrician. Remove the fixture and the mounting package from the box and make sure that no
parts are missing by referencing the illustrations on the installation instructions. Tools are
required when installing this fixture.
REQUIRED TOOLS
Phillips Screwdriver
ASSEMBLY AND INSTALLATION
This light can be installed in a horizontal position or a vertical position.
Turn off the power at fuse or circuit breaker
1. Carefully unpack the fixture, lay out all parts on a clean surface.
2. Fasten the CROSS BAR onto the OUTLET BOX by using 2 OUTLET BOX SCREWS provided..
3. Tie ground wire from OUTLET BOX and from fixture to the GROUND SCREW on the CROSS BAR.
Connect white wire from fixture to white wire (neutral wire) from supply circuit. Connect black wire from
fixture to black wire (live wire) from supply circuit. Cover connections using provided WIRE CONNECTORS.
4. Place WALL PLATE over the MOUNTING SCREWS, then secure them with LOCK NUTS until tightened.
5. Place the SHADE over the NIPPLE and WASHER B and secure with the WASHER A and FINIAL tightly.
6. Install the BULB (not included).
Turn on the power at fuse or circuit breaker.
ITEM# 501452
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN.
Customer Service: 1-800-558-8700