User Guide

Installation and Testing Guide Installation and Testing Guide
Step 2
Test Method 1
Test Method 2
Step 1
Open the monitor clip of the webcam and
place it on the upper part of the display, then
connect the USB plug of the webcam to the
computer USB 2.0/3.0 interface. And wait for
the driver to be installed automatically.
Open the software for meeting such as "Zoom", make sure that the microphone and
video options are switched to the options named
"****** webcam", and the webcam
will start to capture real-time images and sounds.
1. Install OBS Studio software.
2. Add video and audio capturing devices "****** webcam".
3. Adjust the resolution/fps type at the same interface or get into the "Configure Video" for
brightness/white balance adjusting purpose. After setup you can start a video recording.
4. Use a video player like "Pot Player" to play the corresponding recorded video/audio, you
can trible-click the "TAB" to check the corresponding format/pixel/fps etc.
1. Download the "Potplayer" application and install it to the PC/laptop.
2. "Alt + D" to open the "****** webcam", you can select different pixels/fps from "Format"
to achieve various clear video recording, after selection please click "OK".
3. "Ctrl + J" to capture the Real-time image of the webcam.
4. Use "Alt + C" to start recording when in the real-time image interface, After recording,
you can also check the specifications of the recorded video through Potplayer.
Capture
Video Capture Device
30°
Note:
If there were no interfaces but Type-C for your laptop,
it required the USB hub of which supports the UVC
protocol to get the webcam worked.