User Manual

ManualsBrandsDenver Manualsaudio & home theatreCRP-514

ENGLISH

FUNCTION AND CONTROLS

1. (AL1) ALARM 1 ON / OFF SET

2. << / TUNE - /MONTH/DAY/DST

3. PROJECTION ON/OFF

4. PROJECTION UNIT

5. PROJECTION TIME/TEMP 180° FLIP

6. >> / TUNE +/ C-F/YEAR

7. (AL2) ALARM 2 ON / OFF SET

8. VOLUME DOWN

9. VOLUME UP

10. SNOOZE / SLEEP / DIMMER

11. SET/MEM/M+

12. ON / OFF RADIO / ALARM OFF

13. DISPLAY

14. BATTERY COMPARTMENT

15. RATING LABEL

16. SPEAKER

17. TEMPERATURE SENSOR(IN DOOR)

18. FM ANTENNA

19. AC POWER CORD

20. FOCUS ADJUSTMENT FOR PROJECTION UNIT

ENG-1

DENVER CRP-514

Summary of content (6 pages)

PAGE 1
DENVER CRP-514 ENGLISH FUNCTION AND CONTROLS 1. (AL1) ALARM 1 ON / OFF SET 2. << / TUNE - /MONTH/DAY/DST 3. PROJECTION ON/OFF 4. PROJECTION UNIT 5. PROJECTION TIME/TEMP 180° FLIP 6. >> / TUNE +/ C-F/YEAR 7. (AL2) ALARM 2 ON / OFF SET 8. VOLUME DOWN 9. VOLUME UP 10. SNOOZE / SLEEP / DIMMER 11. SET/MEM/M+ 12. ON / OFF RADIO / ALARM OFF 13. DISPLAY 14. BATTERY COMPARTMENT 15. RATING LABEL 16. SPEAKER 17. TEMPERATURE SENSOR(IN DOOR) 18. FM ANTENNA 19. AC POWER CORD 20.
PAGE 2
POWER CONNECTION Plug the AC power cord to a household outlet AC source. This unit is equipped with a battery back up system, it requires a 3V CR2032 flat lithium battery (not included). Insert the battery in the battery compartment, making certain that the positive and negative (+ and -) battery terminals are attached to the corresponding terminals on the plate in the battery compartment.
PAGE 3
Action (during data adjustment): - Press << / Tune - (2) button to adjust data backward. - Press >> / Tune + (6) button to adjust data forward. - Keep depressed << or >> button for 2 seconds to enable auto forward. - Use AL1 / AL2 set button to confirm each setting. ALARM Beep alarm or radio alarm will ring for 30 minutes if no key is pressed, then it will stop automatically and wait for same alarm time on next day.
PAGE 4
To recall the radio preset To recall a preset station, press MEM.SET/M+ (11) button to select the desired preset number. SLEEP OPERATION When you listen to the radio, press the SNOOZE/SLEEP/DIMMER (10) button to enter into the sleep mode. You can adjust the sleep timer from 90 minutes to 15 minutes by pressing repeatedly the SNOOZE/SLEEP/DIMMER button (10). When sleep timer is selected, the unit will automatically turn off once time is up.
PAGE 5
RESETTING If the system does not respond or exhibits erratic or intermittent operation, you may have experienced an electrostatic discharge (ESD) or a power surge that triggered the internal microcontroller to shut down automatically. If this occurs, simply disconnect the ac power cord and remove the system backup battery, wait for at least 3 minutes and then setup the unit again as if it is a brand new unit. WARNING 1. No naked flame sources, such as lighted candles, should be placed on the apparatus. 2.
PAGE 6
ALL RIGHTS RESERVED, COPYRIGHT DENVER ELECTRONICS A/S www.denver-electronics.com Electric and electronic equipment contains materials, components and substances that can be hazardous to your health and the environment, if the waste material (discarded electric and electronic equipment) is not handled correctly. Electric and electronic equipment is marked with the crossed out trash can symbol, seen below.