Installation Instructions

Familiar with this product
Products matching
The product installation
Technical parameters
Precautions for Use
Familiar with this product
The remote control
Key: After pressing the key, the remote control sends out the wireless signal.
LED display: Press the key of remote control, the LED will light up for 3 seconds and then
go out.
Battery compartment: two NO.7 batteries
The receiving end
Battery case: DC 5V
Signal line: IR Signal
Working principle: When the key of the remote control is pressed, wireless data will be
sent to the receiver, and then the data will be sent to the main control board in the form
of IR signal.
Products matching
Long press the stop key for 3 seconds, 1, 3, 5LED lights flash and start the remote
control pairing function. At this time, release the remote control button to power the
smart toilet. If the matching is successful, 5 leds of the remote control will be on for 3
seconds and turn off. If the pairing fails, the 1,3 and 5LED flashes for 30 seconds and
automatically stops. If you want to quit the pairing, you can press the stop key to quit.
Technical parameters
Operating frequency: 2405MHz, 2422MHz, 2450MHz, 2470MHz, a total of four channels
Modulation: GFSK
Transmission rate: 2Mbps
Rf transmission power: 7dbm
Operating temperature: -40℃ ~ 85℃
Precautions for Use
• Try to avoid putting the product where the rain directly wets it.
• Operate according to the pairing instructions, otherwise it cannot be used normally.
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are