Installation Manual

ManualsBrandsDENSO ManualsElectronicsRFID Module

For OEM integration only – device cannot be sold to general public.

Therefore we will ask OEM to include the following statements required

by FCC on the product and in the Installation manual Notice.

DWUL07 RFID Module Installation Manual

Contents

1.Module dimesitons

2.Supply Voltage

3.I/F Connector Pin configuration

4.Notice

Summary of content (8 pages)

PAGE 1
DWUL07 RFID Module Installation Manual For OEM integration only – device cannot be sold to general public. Therefore we will ask OEM to include the following statements required by FCC on the product and in the Installation manual Notice. Contents 1.Module dimesitons 2.Supply Voltage 3.I/F Connector Pin configuration 4.
PAGE 2
1.
PAGE 3
2. Supply Voltage Symbol Parameter Conditions Min. Typ. Max. Unit VBAT Battery supply voltage Internal supply voltage 3.6 - 4.35 V D5V Supply voltage Internal supply voltage 4.55 - 4.
PAGE 4
3.
PAGE 5
4. Notice Please describe the following warning on the final product which contains this module. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Please describe the following warning to the manual.
PAGE 6
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
PAGE 7
End Product Labeling The final end product must be labeled in a visible area with the following: “Contains FCC ID: PZWDWUL07”. The grantee's FCC ID can be used only when all FCC compliance requirements are met. Manual Information To the End User The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the user’s manual of the end product which integrates this module.
PAGE 8
Cet appareil est conçu uniquement pour les intégrateurs OEM dans les conditions suivantes: 1) Le module émetteur peut ne pas être coïmplanté avec un autre émetteur ou antenne. Tant que les 1 condition ci-dessus sont remplies, des essais supplémentaires sur l'émetteur ne seront pas nécessaires. Toutefois, l'intégrateur OEM est toujours responsable des essais sur son produit final pour toutes exigences de conformité supplémentaires requis pour ce module installé.