Jun 10, 2014 DWBT013 Installation Manual Contents 1. Supply Voltage 2. Dimensions and Connector specification 3.
Jun 10, 2014 1. Supply Voltage Item Specifications Supply Voltage DC 3.3V Supply Voltage Range (Note) DC 3.0-3.6V Note: These values are specified at the connector terminal.
Jun 10, 2014 2. Dimensions and Connector specification (31mm) (Electronic components were omitted) (15mm) Label (3mm) Connector Specification: 0.
Jun 10, 2014 3. Notice This device complies with part 15 of the FCC Rules and RSS-Gen of IC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference, including interference that may cause undesired operation of this device. Le présent appareil est conforme aux la partie 15 des règles de la FCC et CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
Jun 10, 2014 FCC CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. Radiation Exposure Statement: The product comply with the FCC and Canada portable RF exposure limit set forth for an uncontrolled environment and are safe for intended operation as described in this manual.
Jun 10, 2014 This device is intended only for OEM integrators under the following conditions: 1)The transmitter module may not be co-located with any other transmitter or antenna. 2)Module approval valid only when the module is installed in the tested host or compatible series of host As long as 2 conditions above are met, further transmitter test will not be required.
Jun 10, 2014 Please describe the following warning on the End product which contains this module.