User Manual

ManualsBrandsDenso Wave ManualsElectronicsBar Code Reader with Bluetooth

Operation manual

1. Data communication with potable printer.

(1) Registration of portable printer and selection of the portable printer

- Transmits the registration signal from potable printer and register the portable printer at the BHT-8000.

- Transmits the selection signal from BHT-8000 to the portable printer and connect the BHT-8000 with

portable printer.

(2) Bar code reading and data transfer

BHT-8000 reads the bar code and transmits the reading data to portable printer. Portable printer

prints the receipt.

2. Data communication in public circuit

(1) Registration of cell phone and selection of the cellular phone

- Transmits the registration signal from cellular phone and register the cellular phone at the BHT-8000.

- Transmits the selection signal from BHT-8000 to the cell phone and connect the BHT-8000 with cellular

phone.

(2) Bar code reading and call

When BHT-8000 reads the bar code, the reading data is transmitted from cellular phone to the host

by public circuit.

Bar code

Bluetooth RF signal

Cellular RF signal

Host

modem

Bar code

Summary of content (6 pages)

PAGE 1
Operation manual 1. Data communication with potable printer. (1) Registration of portable printer and selection of the portable printer Bluetooth RF signal - Transmits the registration signal from potable printer and register the portable printer at the BHT-8000. - Transmits the selection signal from BHT-8000 to the portable printer and connect the BHT-8000 with portable printer.
PAGE 2
Components and Functions Indication LED Illuminates in green when the BHT has successfully read the bar codes. Built-in antenna Used for Bluetooth wireless communication. Do not cover this by hand. Doing so may result in communications failures. Trigger switch (M4 key) Press this switch to start bar-code reading. Liquid crystal display (LCD) Shows the characters and graphic patterns. Trigger switch (M3 key) Press this switch to start bar-code reading.
PAGE 3
8
PAGE 4
Reading Bar Codes Turn the BHT on, bring the bar-code reading window to the bar code to be scanned, and press the trigger switch. The BHT turns on the illumination LED to scan the bar code. When the BHT has read the bar code successfully, the indicator LED will illuminate in green. · If the BHT fails to read due to specular effects or other factors, change the scanning angle of the reading window or the distance from codes as shown at right, and try it again.
PAGE 5
· Before reading labels, clean them if stained. · Avoid using the BHT in direct sunlight. The BHT might fail to read correctly. · To read bar codes on curved surfaces, apply the bar-code reading window to the center of each bar code at a right angle. · If you pull the bar-code reading window away from bar codes, the actual scanning range will become narrower than the range covered by the illumination LED.
PAGE 6
Using Bluetooth™ The BHT-8000DB supports Bluetooth wireless data transmission. · If there are too many communications errors, first make sure that the BHT points directly at an access point because the 2.4 GHz band requires a more or less straight line path. Note also that the low-power radio waves have trouble passing through human bodies and other obstacles along that path. · In the vicinity of wireless LAN devices using radio waves in the 2.