RFID System Antenna Controller Instruction Manual Ver : 0.92 Apr. 2012 High Frequency 13.56MHz Transceiver AN10R-01 : Square Antenna with controller CTAN10R-01 : M12 Cylinder Antenna with controller This Instruction Manual sets forth the procedures for handling and precautions. Before use, read through this guide carefully to make sure that you use the antenna controller both correctly and effectively. Also keep it handy for ready reference.
DECLARATION OF CONFORMITY For European Union [EN] Hereby, DENSO WAVE INCORPORATED declares that this HIGH FREQUENCY English 13.56MHz TRANSCEIVER is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. [BG] С настоящето, DENSO WAVE INCORPORATED, декларира, че HIGH Bulgarian FREQUENCY 13.56MHz TRANSCEIVER е в съответствие със същест вените изисквания и другитеприложими разпоредби на Директива 1999/5/EC.
[NL] Dutch [PL] Polish [PT] Portuguese [RO] Romanian [SK] Slovak [SL] Slovenian [FI] Finish [SV] Swedish Hierbij verklaart DENSO WAVE INCORPORATED dat het toestel l HIGH FREQUENCY 13.56MHz TRANSCEIVER in overeenstemming is met de essentiële eisen en de andere relevante bepalin-gen van richtlijn 1999/5/EG. Niniejszym DENSO WAVE INCORPORATED deklaruje że HIGH FREQUENCY 13.56MHz TRANSCEIVER jest zgodny z zasadniczymi wymaganiami iinnymi właściwymi postanowieniami Dyrektywy 1999/5/EC.
FCC and IC Regulations (For North America) ■NOTICE This device complies with Part 15 of FCC Rules and Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference. (2) this device must accept any interference, including interference that may cause undesired operation of this device.
中国SRRC 1. 本产 品的使用方法等请 参见 产 品说 明书 。本产 品的技术 参数如下： ■ ■ ■ ■ ■ 使用频 率为 ：13.553-13.567MHz 所发 射的电 场 强 度在距设 备 10 米处 不得超过 42dBμA/m(采用准峰 值 检 波)； -6 频 率容限：≤100×10 杂 散辐 射：对 于 13.553-13.567MHz 频 段设 备 ，频 段两端偏移 140kHz 频 率范围 的限值 为 9dBμA/m（10 米处 ，准峰值 ） 杂 散辐 射等其他技术 指标 请 参照 2005/423 号文件 2. 使用者不得擅自更改发 射频 率、加大发 射功率(包括额 外加装射频 功率放大器)，不得擅自外接 天线 或改用其它发 射天线 ； 3. 使用时 应 注意不得对 各种 合法的无线 电 通信业 务 产 生有害干扰 ；一旦发 现 有干扰 现 象时 ，应 立 即停止使用，并采取措施消除干扰 后方可继 续 使用； 4. 本产 品为 微功率无线 电 设 备 ，能够 承受各种 无线 电 业 务 的干扰 或工业 、科学及医疗 应 用设 备 的 辐 射干扰 ； 5.
SAFETY PRECAUSIONS Be sure to observe all these safety precautions. Please READ through these instructions carefully. They will enable you to use the scanner correctly. Always keep this manual nearby for speedy reference. Strict observance of these warnings and cautions is a MUST for preventing accidents that could result in bodily injury and substantial property damage. Make sure you fully understand all definitions of these terms and symbols given below before you proceed to the text itself.
To System Designers When introducing the product in those systems that affect human lives, develop applications carefully through redundancy and safety design which avoids the feasibility of affecting human lives even if a data error occurs. Installation Do not use the product in places where use of radio waves is restricted, such as on airplanes or in hospitals. Doing so could case malfunction in electronic devices or medical equipment.
CAUTION Operating environments and Installation Never put the product in places where there are excessively high temperatures, such as inside closed-up automobiles, in places exposed to direct sunlight, or in places generating heat accumulation caused by radiant, etc. Doing so could affect the parts, resulting in a fire. Avoid using the product in extremely humid, dusty areas or, where there are drastic temperature changes.
Specification z AN10R-01: Square Antenna with controller/ CTAN10R-01: M12 Cylinder Antenna with controller Item Specification Supply Voltage 8.5Vdc (Class 2 Power source or Limited energy circuit ) Current Consumption 0.23A (at 8.
External dimensions (Unit: mm) AN10R-01: Square Antenna with controller z LED z Connector (HRS, HR30-7P-12S(71)) Connector Pin No. Name Direction Explanation 1, 7 GND - 2, 8 8.
z CTAN10R-01: M12 Cylinder Antenna with controller Controller (CTAN10R-01) LED Note: Ferrite core requires careful handling. Failure to do so could cause a drop or strong shock, resulting in break. M12 Cylinder Antenna (AN11R-02) Note: Screw thread requires careful handling. Failure to do so could cause a drop or strong shock, resulting in break.
System Configuration Example) PLC or PC RS-232C IFAN10R-RS-02 RS-422/ -485 CTAN10R-01 Power Supply AN10R-01 AN11R-02 Tag TG10R-01 Tag TG11R-01 12
Specifications to communicate with the host device Item Specification Communication System Half Duplex (RS-422) Baud Rates 9600 / 19200 / 38400 / 115200bps (Default: 38400bps) Data Length 8bit Stop Bit Length 1bit Error Detection Parity bit even Cable Length Max. 500m (from PLC to Transceiver) ※ For more information, see the Programming Manual.
About This Manual Specifications are subject to change without prior notice. z z No part of this publication may be reproduced in any form or by any means without permission in writing from the publisher. z Please contact DENSO WAVE if you loose this document. z DENSO WAVE has taken all possible means to ensure this document. Please inform us if you have any doubt or find mistakes or missing in the contents of this document.
