User Guide Guía del usuario Guide d’utilisation Guida per l’uso Benutzerhandbuch Appendix English (3–6) Español (7–10) Français (11–14) Italiano (15–18) Deutsch (19–22) English (23)
User Guide (English) Introduction Thank you for purchasing the DN-470A. At Denon Professional, performance and reliability mean as much to us as they do to you. That’s why we design our equipment with only one thing in mind—to make your performance the best it can be.
5 4 3 1 6 2 Features Front Panel 3 3 1 4 2 2 2 2 1. Power Switch: Press this switch to power DN-470A on or off. 2. Level Knobs: Turn these knobs to set the output level for each channel. 3. Signal/Clip/Protection LEDs: These lights will illuminate different colors to show the signal status of each channel input: 4. • Signal LED: The input’s Signal LED will be lit green when it is receiving a signal at an optimal level.
Setup Items not listed under Introduction > Box Contents are sold separately. 1. Use the included Euroblock connectors to connect the inputs on the rear panel to your audio sources. • Each channel input has a ground (G), cold/negative (–), and hot/positive (+) connector. 2. Use the included Euroblock connectors to connect the outputs on the rear panel to your loudspeakers. • Each channel output has a switch for 70V and 100V. 3. Use the included power cable to connect the power inlet to a power outlet.
Using a Euroblock Connector 1. Twist the speaker wire to form a tight strand and insert this into the appropriate port, pushing the wire until it is secured inside. 2. Attach the Euroblock connector to the terminal on DN-470A. 3. To disconnect a wire, use a small screwdriver to press in the spring above the insert port while pulling out the wire.