User's Manual

ManualsBrandsDelta ManualsElectronicsBT Module

NSW1000BLE User Manual

BT Module User Manual

(Model : NSW1000-BLE)

Notice:

1. Delta Networks Inc. reserves the right to change specifications detailed in this document at any time without notice,

and assumes no responsibility for any errors within this document.

2. This document contains proprietary technical information in which is the property of the Delta Networks inc. and shall

not be disclosed to others in whole or in part, reproduced, copied, or used as the basis for design, manufacturing, or

sale of apparatus without written permission of Delta Networks Inc.

Summary of content (7 pages)

PAGE 1
BT Module User Manual (Model : NSW1000-BLE) Notice: 1. Delta Networks Inc. reserves the right to change specifications detailed in this document at any time without notice, and assumes no responsibility for any errors within this document. 2. This document contains proprietary technical information in which is the property of the Delta Networks inc.
PAGE 2
1. Product Overview 1.1. Features Features: □ UART interface □ Class 1 Bluetooth power level supported □ High-sensitivity Bluetooth receiver □ I-PEX connector Bluetooth Version Bluetooth Technology Data Rate Operating Frequencies Sensitivity Bluetooth 4.1 Bluetooth Low Energy 1Mbps 2.402 ~ 2.480GHz -88dBm Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules.
PAGE 3
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
PAGE 4
This module is intended for OEM integrators only. Per FCC KDB 996369 D03 OEM Manual v01 guidance, the following conditions must be strictly followed when using this certified module: KDB 996369 D03 OEM Manual v01 rule sections: 2.2 List of applicable FCC rules This module has been tested for compliance to FCC Part 15C 2.3 Summarize the specific operational use conditions The module is tested for standalone mobile RF exposure use condition.
PAGE 5
2.10 Additional testing, Part 15 Subpart B disclaimer This transmitter module is tested as a subsystem and its certification does not cover the FCC Part 15 Subpart B (unintentional radiator) rule requirement applicable to the final host. The final host will still need to be reassessed for compliance to this portion of rule requirements if applicable. As long as all conditions above are met, further transmitter test will not be required.
PAGE 6
L’exploitation est autorisée aux deux conditions suivantes : (1) le dispositif ne doit pas produire de brouillage préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu, y compris un brouillage susceptible de provoquer un fonctionnement indésirable. Radiation Exposure Statement: This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with greater than 20cm between the radiator & your body.
PAGE 7
plus considéré comme valide et l'ID IC ne peut pas être utilisé sur le produit final. Dans ces circonstances, l'intégrateur OEM sera chargé de réévaluer le produit final (y compris l'émetteur) et l'obtention d'une autorisation distincte au Canada. End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed and operated with greater than 20cm between the antenna and users.