Specifications

Tub and Shower
MultiChoice™ universal valve body only with Push
Button Diverter
with screwdriver stops and 1/2" universal inlets/outlets
Model No: R10300-UNWS
SPECIFICATION:
•
Forged brass body
•
Back-to-Back installation capabilities
•
Can be tested with air (200 psi) or water (300 psi) without valve using
supplied test cap
•
Square plasterguard allows for right angle cuts.
•
For use with MultiChoice® Universal single or dual function trim.
•
Cartridge ships with trim.
•
1/2" outlets and connections.
•
With push button diverter
•
1/2" NPT male thread with 1/2" C.W.T. female sweat with screwdriver stops
COMPLIES WITH:
•
ASME A112.18.1 / CSA B125.1
•
(Contact Delta Representative for State and/or Local Approvals)
(Dimensional drawing on following page)
•
Not Available
OPERATION:
Delta reserves the right (1) to make changes to specifications and materials, and (2) to change or discontinue models, both without notice or obligation. Dimensions are for reference.
Measurement may vary plus or minus 6mm(0.25"). Mounting locations are suggested only. Check with local codes for requirements in your area. This spec was produced September 03, 2015.
- 1.0.23445
Page of1 2
Delta Faucet Company - 55 East 111th St. - Indianapolis, Indiana, USA 46280 - [phone]
Delta Faucet Canada - 395 Matheson Blvd E - Mississauga, Ontario, Canada L4Z 2H2 - [phone]