Installation Guide

ManualsBrandsDelta ManualsBathDryden Battery-Powered Single Hole Single-Handle Vessel Bathroom Faucet with Touch2O.xt Technology in Polished Nickel

3/1/13 Rev. D

SILICONE

Model/Modelo/Modèle

538T-DST, 15938T-DST, 15960T-DST,

551T-DST , 751T-DST & 15901T-DST

Series/Series/Seria

Para instalación fácil de su llave Delta

usted necesitará:

• LEER TODAS las instrucciones completamente

antes de empezar.

• LEER TODOS los avisos, cuidados, e

información de mantenimiento.

For easy installation of your Delta

faucet you will need:

• To READ ALL the instructions completely

before beginning.

• To READ ALL warnings, care, and

maintenance information.

SILICONE

Write purchased model number here.

Escriba aquí el número del modelo comprado.

Inscrivez le numéro de modèle ici.

You may need/Usted puede necesitar/

Articles dont vous pouvez avoir besoin:

Pour installer votre robinet Delta

facilement, vous devez:

• LIRE TOUTES les instructions avant de débuter;

• LIRE TOUS les avertissements ainsi que toutes

les instructions de nettoyage et d’entretien;

SILICONE

ASME A112.18.1 / CSA B125.1

ASME A112.18.2 / CSA B125.2

ICC/ANSI A117.1

SINGLE HANDLE LAVATORY TOUCH CENTERSET

FAUCETS - RECOMMENDED FOR USE ON

NON METALLIC SINKS

LLAVES DE AGUA – GRIFOS – MONOMANDO

MONOBLOC PARA LAVAMANOS – SE RECOMIENDA

PARA EL USO EN LAVAMANOS NO METÁLICOS

ROBINETS CENTERSET TACTILES À UNE MANETTE

POUR LAVABO - RECOMMANDÉS POUR UNE

UTILISATION SUR DES LAVABOS NON MÉTALLIQUES

1/8"

64598

SILICONE

Summary of content (12 pages)

PAGE 1
SINGLE HANDLE LAVATORY TOUCH CENTERSET FAUCETS - RECOMMENDED FOR USE ON NON METALLIC SINKS LLAVES DE AGUA – GRIFOS – MONOMANDO MONOBLOC PARA LAVAMANOS – SE RECOMIENDA PARA EL USO EN LAVAMANOS NO METÁLICOS ROBINETS CENTERSET TACTILES À UNE MANETTE POUR LAVABO - RECOMMANDÉS POUR UNE UTILISATION SUR DES LAVABOS NON MÉTALLIQUES 64598 ASME A112.18.1 / CSA B125.1 ASME A112.18.2 / CSA B125.2 ICC/ANSI A117.
PAGE 2
1 1 For Three Hole Mount Para Las Instalaciones De Tres Agujeros Montage Sur Trois Trous A. For Single Hole Mount Para Las Instalaciones De Un Agujero Montage sur un trou A. Back 1 1 2 2 3 Front B. B. 4 Top 5 Top 3 3 4 4 5 6 For three hole mount: For single hole mount: A. Slide spacer with LED (1), foam gasket (2) and escutcheon (3) up over tubes, A. Slide spacer with LED (1) and single hole gasket (2) up over tubes LED wire and mounting stud.
PAGE 3
2 B. A. 2 2 4 3 1 1 1st 2 3 2 2 2nd 4 3 1 3 1 2 1 3 1 3rd Solenoid Installation A. From underneath the sink, slide the solenoid assembly (1) onto the valve outlet (2). Make sure that the assembly is fully engaged; then, slide the metal retaining clip (3) through the thin slots on top of the solenoid inlet (4). Pull down moderately to ensure connection has been made. An incorrectly installed clip could cause water damage. B. Push hose end (1) onto solenoid assembly outlet (2).
PAGE 4
A. 3 B. C. 10 AA 1 AA 2 9 AA 5 AA 4 6 8 7 10 D. 1 1 6 3 1 4 5 3 Wire Connections A. Briefly touch the cold stop or other ground to dissipate any static charge. Wire (1) from the faucet is shipped with a protective plastic cap (2) on the connector. Remove this by grasping the plug and pulling off the cap. Discard cap. Plug wire (1) into port (3) on the solenoid assembly. Avoid twisting any wires together or placing the wires close to each other. Conexiones de Alambre A.
PAGE 5
4 C. A. D. 1 OR B. 2 2 4 O 3 OU 3 1 4 Water Line Connections A. Important: To ensure proper operation of your plumbing it is essential to install these check valve assemblies onto your supply stops. Insert ferrule (1) into cold water stop. B. Thread on check valve (2) and tighten. DO NOT OVERTIGHTEN. Repeat steps A & B for hot water stop. C. Ensure all fittings and end connections are free of debris. Faucet fittings (1) are 3/8" compression, with ends colored red for hot and blue for cold.
PAGE 6
Incorrect Installation Instalación Incorrecta Installation Incorrecte Correct method Método Correcto Bonne méthode 2 3 1 4 Custom Fit Connections - Plastic Sleeve Installation Instructions 1. Identify desired length of tube (1). Leave 1" - 2" of extra length to allow for easier installation and cut tube. Ensure cut is straight and burr free. 2. Slide nut (2) and plastic sleeve (3) onto cut tube. Ensure sleeve is oriented as shown. 3. Insert tube into outlet ﬁtting (4).
PAGE 7
5 C. A. 1 3 5 4 2 2 4 1 3 6 B. D. 4 1 4 5 2 4 3 3 1 2 6 Pop-Up *Pop-up provided must be installed for proper faucet operation. A. Remove stopper (1) and flange (2). Screw nut (3) all the way C. Remove pivot nut (1). Install horizontal rod (2) and stopper (3) B. Apply silicone to underside of flange (1). Insert body (2) into sink. Screw flange onto body. Pivot hole (3) must face back of sink. Pull assembly down firmly and hold in place. DO NOT TWIST.
PAGE 8
6 7 3 1 2 1 2 Setting The Handle Limit Stop (Optional) 4 4 Remove aerator (1) using supplied wrench (2) and turn faucet handle (3) to the full on mixed position. Turn on hot and cold water supplies (4) and flush water lines for one minute. Important: This flushes away any debris that could cause damage to internal parts. Reinstall aerator with wrench. Note: For future use, aerator wrench (2) can be clipped to the supply line after flushing faucet. Check all connections at arrows for leaks.
PAGE 9
Cleaning the Screen / Filtro de Limpieza: / Nettoyage du ﬁltre B-2 B-1 7 3 Note: If red light (8) is blinking 2 seconds on then 2 seconds off, call Delta Customer Service at 1-800-345-DELTA. 6 Nota: Si la luz roja (8) está destellando durante 2 segundos cuando está prendido y 2 segundos cuando está apagado, llame al departamento de Servicio al Consumidor al 1-800-345-DELTA.
PAGE 10
64598 Rev.
PAGE 11
64598 Rev.
PAGE 12
Limited Warranty on Delta® Faucets Parts and Finish All parts (other than electronic parts and batteries) and finishes of this Delta® faucet are warranted to the original consumer purchaser to be free from defects in material and workmanship for as long as the original consumer purchaser owns the home in which the faucet was first installed or, for commercial users, for 5 years from the date of purchase.