Operating Guide

1
07/21/2020 Rev. B
Write purchased model number here.
Escriba aquí el número del modelo comprado.
INSTALLATION INSTRUCTIONS FOR
ADJUSTABLE WALL BAR
Models
55024p & 55030p
Series
www.deltafaucet.com
pDesignate proper finish suffix
72632
The installation of your new Delta
®
adjustable bar unit is simple and easy requiring
no special tools or skills. Caution: Use care to avoid marring or scratching
chromed and plastic surfaces. A personal shower offers numerous possibilities
of connections to water supply. The hose will connect easily to the shower arm,
elbow at the shower outlet, Delta
®
shower diverter (permitting existing shower to
remain in use), or Delta
®
diverter tub spout (permitting this shower to be added to
baths without a shower). It is important to establish your water supply connections
first, as this avoids mounting the bar too far from the water supply outlet, creating
excessive strain on flexible hose. As subsequent instructions specify, the bar
should be mounted in a vertical position at the most convenient height.
Conversion of Water Supply
Conventional Water Supply
For wall shower/hand shower use.
Installation:
1. Remove existing shower head from shower arm.
2. Attach flexible hose to exposed threads on shower arm using gasket.
Installation:
1. Remove existing shower head and escutcheon from shower arm.
2. Mark shower arm at wall and remove shower arm replacing it with a nipple 1/2 inch
longer than unexposed length of shower arm to the mark.
3. Attach Delta
®
supply elbow with flange onto nipple and tighten securely. Caution:
Do not twist supply pipe in wall.
4. Attach hose to supply elbow using gasket provided.
Shower Diverter Water Supply For use with existing shower.
Installation:
1. Remove shower head by turning counter clockwise.
2. Attach female threaded end of shower diverter to shower arm, using gasket
supplied. Do not overtighten.
3. Replace shower head onto end af diverter shower. A sealant such as pipe compound
or plumber tape may be required to prevent water seepage.
4. Attach flexible hose to shower diverter using gasket supplied. Do not overtighten.
Tub Spout Water Supply For baths without shower.
Installation:
1. Remove present tub spout by turning counter clockwise.
2. Replace with Delta
®
diverter tub spout following directions enclosed inside
package.
Hose Care
Your hose is of high quality chrome plated spiral wound around a rubber inner liner. It will provide many years of quality performance with proper care. Avoid the
following conditions which may weaken or damage your hose and void your warranty.
Do not pull, strain, stretch, or jerk hose.
Do not wind, twirl or twist hose.
Do not bend, knot, coil or crimp hose.
1.
Select Location
Your bar unit is a beautiful bath
accessory and should be located so it
looks good and performs as intended.
Pictured are some typical installations
as suggestions only, pick a location that
suits your family’s needs.
Select a convenient height based on
your family’s needs. Note: Locate so
there will be slack in the hose when
shower is in extreme up or down
position.
2.